Whirlpool W10057363B installation instructions Connect vent, Level dryer

Page 17

Connect vent

1. Connect vent to exhaust outlet

Using a 4" (102 mm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure vent is clean. Dryer vent must fit over dryer exhaust outlet and inside exhaust hood. Check that vent is secured to exhaust hood with a 4" (102 mm) clamp.

2. Move dryer to final location

Move dryer to final location, taking care not to crush or kink vent.

After dryer is in place, remove corner posts and cardboard from under dryer.

Level dryer

1. Level dryer

Place

level here

Check levelness of dryer from

side to side. Repeat from front to back.

NOTE: The dryer must be level for the moisture sensing system to operate correctly.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Not Level

 

LEVEL

 

 

 

Not Level

2. Adjust leveling legs

If dryer is not level, prop up using a wood block, use wrench to adjust legs up or down, and check again for levelness. Once dryer is level, make sure all four legs are snug against the floor and dryer does not rock.

17

Image 17
Contents Electric Dryer Installation Instructions Dryer Safety If using a power supply cord Installation RequirementsTools needed Parts suppliedLocation Requirements Installation ClearancesElectrical Requirements If connecting by direct wire Install Leveling LegsPrepare dryer for leveling legs Screw in leveling legsFor direct wire installations Electric InstallationFor power supply cord installations Attach power supply cord Power Supply Cord ConnectionPrepare to connect neutral ground wire and neutral wire Connect neutral ground wire and neutral wireConnect remaining wires Connect ground wireConnect neutral wire Remove center screwDirect wire strain relief Attach direct wire strain relief Direct Wire ConnectionAttach direct wire cable to strain relief Wire Direct Wire ConnectionWire Direct Wire Connection Prepare your 3-wire cable for direct connectionPower Supply Cord Shown Optional External Ground for 3-Wire ConnectionConnect external ground wire Venting Venting Requirements Determine vent path Plan Vent SystemSpecial provisions for mobile homes Connect Inlet Hose Install Vent SystemAttach long hose to dryer fill valve and tighten coupling Attach long hose to Y connector and tighten couplingsTurn on cold water faucet Check for leaksLevel dryer Connect ventChecklist Complete InstallationMove the door strike Door Reversal optionalRemove door from dryer Remove inner door from outer doorReverse outer window assembly Remove outer window assembly from trim ringRemove hinge and latch Rotate and reassemble outer window assembly to trim ringReinstall hinge and latch on opposite sides Reinstall door on dryer Reinstall inner door assemblyPage 2010 11/10 All rights reserved