3. Connect ground wire
A |
F |
Connect ground wire (F) (green or bare) of power supply cord under green external ground conductor screw (A). Tighten screw.
4. Connect remaining wires
Connect remaining wires under outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with
Use where local codes permit connecting
1. Remove center screw
B |
Remove center terminal block screw (B).
2. Connect neutral wire
B |
C |
Connect neutral wire (white or center) (C) of power supply cord under center terminal block screw (B). Tighten screw.
3. Connect remaining wires
|
|
| Connect remaining wires under outer terminal block screws. |
| Tighten screws. Finally, reinsert tab of terminal block cover | ||
type |
|
| into slot of dryer rear panel. Secure cover with |
|
|
| screw. Now, go to Venting Requirements. |
|
|
|
|
Spade terminals with | Ring terminals |
upturned ends |
|
9