Whirlpool W10057363B Electric Installation, For power supply cord installations

Page 7

ELECTRIC INSTALLATION

For power supply cord installations:

Before you start: disconnect power.

1. Choose electrical connection type

Power supply cord 4-wire receptacle (NEMA Type 14-30R).

Go to Power Supply Cord Connection.

Power supply cord 3-wire receptacle (NEMA Type 10-30R).

Go to Power Supply Cord Connection.

4-wire direct connection:

Go to Direct Wire Connection.

3-wire direct connection:

Go to Direct Wire Connection.

NOTE: If local codes do not permit connection of a cabinet-ground conductor to neutral wire, go to “Optional 3-wire connection”. This connection may be used with either a power supply cord or a direct wire connection.

For direct wire installations:

2. Remove terminal block cover

Remove hold-down screw and terminal block cover.

7

Image 7
Contents Electric Dryer Installation Instructions Dryer Safety Parts supplied Installation RequirementsIf using a power supply cord Tools neededLocation Requirements Installation ClearancesElectrical Requirements Screw in leveling legs Install Leveling LegsIf connecting by direct wire Prepare dryer for leveling legsFor power supply cord installations Electric InstallationFor direct wire installations Connect neutral ground wire and neutral wire Power Supply Cord ConnectionAttach power supply cord Prepare to connect neutral ground wire and neutral wireRemove center screw Connect ground wireConnect remaining wires Connect neutral wireWire Direct Wire Connection Direct Wire ConnectionDirect wire strain relief Attach direct wire strain relief Attach direct wire cable to strain reliefWire Direct Wire Connection Prepare your 3-wire cable for direct connectionConnect external ground wire Optional External Ground for 3-Wire ConnectionPower Supply Cord Shown Venting Venting Requirements Special provisions for mobile homes Plan Vent SystemDetermine vent path Connect Inlet Hose Install Vent SystemCheck for leaks Attach long hose to Y connector and tighten couplingsAttach long hose to dryer fill valve and tighten coupling Turn on cold water faucetLevel dryer Connect ventChecklist Complete InstallationRemove inner door from outer door Door Reversal optionalMove the door strike Remove door from dryerReverse outer window assembly Remove outer window assembly from trim ringReinstall hinge and latch on opposite sides Rotate and reassemble outer window assembly to trim ringRemove hinge and latch Reinstall door on dryer Reinstall inner door assemblyPage 2010 11/10 All rights reserved