Whirlpool W10057363B Remove outer window assembly from trim ring, Reverse outer window assembly

Page 20

4. Remove outer window assembly from trim ring

A

B

Using a Phillips screwdriver, remove the 2 screws from the outer window retainer and rotate the outer window assembly clockwise until the square notches line up with the 4 tabs on the trim ring indicated with arrows in the figure A above. Then lift out the outer window and retainer up and off the trim ring and set aside (B).

5. Reverse outer window assembly

Handle

A

Handle

B

Using a Phillips screwdriver, remove the 4 screws from the outer window retainer and lift off the trim ring off the window

(A). Rotate trim ring 180° and secure with the 4 screws removed earlier (B).

20

Image 20
Contents Electric Dryer Installation Instructions Dryer Safety Installation Requirements If using a power supply cordTools needed Parts suppliedInstallation Clearances Location RequirementsElectrical Requirements Install Leveling Legs If connecting by direct wirePrepare dryer for leveling legs Screw in leveling legsFor direct wire installations Electric InstallationFor power supply cord installations Power Supply Cord Connection Attach power supply cordPrepare to connect neutral ground wire and neutral wire Connect neutral ground wire and neutral wireConnect ground wire Connect remaining wiresConnect neutral wire Remove center screwDirect Wire Connection Direct wire strain relief Attach direct wire strain reliefAttach direct wire cable to strain relief Wire Direct Wire ConnectionPrepare your 3-wire cable for direct connection Wire Direct Wire ConnectionPower Supply Cord Shown Optional External Ground for 3-Wire ConnectionConnect external ground wire Venting Venting Requirements Determine vent path Plan Vent SystemSpecial provisions for mobile homes Install Vent System Connect Inlet HoseAttach long hose to Y connector and tighten couplings Attach long hose to dryer fill valve and tighten couplingTurn on cold water faucet Check for leaksConnect vent Level dryerComplete Installation ChecklistDoor Reversal optional Move the door strikeRemove door from dryer Remove inner door from outer doorRemove outer window assembly from trim ring Reverse outer window assemblyRemove hinge and latch Rotate and reassemble outer window assembly to trim ringReinstall hinge and latch on opposite sides Reinstall inner door assembly Reinstall door on dryerPage 2010 11/10 All rights reserved