Whirlpool W10057363B installation instructions Complete Installation, Checklist

Page 18

Complete Installation

CHECKLIST

qCheck that all parts are now installed. If there is an extra part, go back through steps to see what was skipped.

qCheck that you have all of your tools.

qDispose of/recycle all packaging materials.

qBe sure the water faucets are on.

qCheck for leaks around “Y” connector, faucet, and hoses.

qCheck dryer’s final location. Be sure vent is not crushed or kinked.

qCheck that dryer is level. See “Level Dryer”.

qRemove film on console and any tape remaining on dryer.

qWipe dryer drum interior thoroughly with a damp cloth to remove any dust.

qRead “Dryer Use” in your Use and Care Guide.

qFor power supply cord installation, plug into a grounded outlet. For direct wire installation, turn on Power.

qIf you live in a hard water area, use of a water softener is recommended to control the buildup of scale through the water system in the dryer. Over time, the buildup of lime scale may clog different parts of the water system, which will reduce product performance. Excessive scale buildup may lead to the need for certain part replacement or repair.

qSelect a Time Dry heated cycle, and start dryer. Do not select Air Only Temperature setting.

If dryer will not start, check the following:

Controls are set in a running or “On” position.

Start button has been pushed firmly.

Dryer is plugged into an outlet and/or electrical supply.

Household fuse is intact and tight, or circuit breaker has not tripped.

Dryer door is closed.

This dryer automatically runs an installation diagnostic routine at the start of its first cycle.

NOTE: You may notice an odor when dryer is first heated. This odor is common when heating element is first used. The odor will go away.

18

Image 18
Contents Electric Dryer Installation Instructions Dryer Safety Tools needed Installation RequirementsIf using a power supply cord Parts suppliedInstallation Clearances Location RequirementsElectrical Requirements Prepare dryer for leveling legs Install Leveling LegsIf connecting by direct wire Screw in leveling legsElectric Installation For power supply cord installationsFor direct wire installations Prepare to connect neutral ground wire and neutral wire Power Supply Cord ConnectionAttach power supply cord Connect neutral ground wire and neutral wireConnect neutral wire Connect ground wireConnect remaining wires Remove center screwAttach direct wire cable to strain relief Direct Wire ConnectionDirect wire strain relief Attach direct wire strain relief Wire Direct Wire ConnectionPrepare your 3-wire cable for direct connection Wire Direct Wire ConnectionOptional External Ground for 3-Wire Connection Connect external ground wirePower Supply Cord Shown Venting Venting Requirements Plan Vent System Special provisions for mobile homesDetermine vent path Install Vent System Connect Inlet HoseTurn on cold water faucet Attach long hose to Y connector and tighten couplingsAttach long hose to dryer fill valve and tighten coupling Check for leaksConnect vent Level dryerComplete Installation ChecklistRemove door from dryer Door Reversal optionalMove the door strike Remove inner door from outer doorRemove outer window assembly from trim ring Reverse outer window assemblyRotate and reassemble outer window assembly to trim ring Reinstall hinge and latch on opposite sidesRemove hinge and latch Reinstall inner door assembly Reinstall door on dryerPage 2010 11/10 All rights reserved