974CIB_06 4/7/06 3:32 PM Page 12

Installation

Battery installation

continued from page 11

3. Pull on the tab to remove the battery compartment cover.

4.Insert a 9V battery (purchased separately) following the polarity markings in the battery compartment.

Polarity markings

5.Replace the battery compartment cover and the screw.

6.If you are wall mounting the phone, turn to Wall installation beginning on page 15. (You will not need the wedge; store it in case you use the phone on a table or desk in the future.)

—OR—

If you are using the phone on a table or desk, reattach the wedge to the base unit by sliding the tabs into the holes as shown. Snap the wedge onto the base. Then, turn to Table/desk installation beginning on page 13.

12

Page 15
Image 15
AT&T 974 user manual Battery installation, Replace the battery compartment cover and the screw