Whirlpool W10057363B Reinstall inner door assembly, Reinstall door on dryer

Page 22

9. Reinstall inner door assembly

Bottom of door

Position the door with the inside of the door facing up. Reinstall the 10 screws securing the inner door to the outer door.

10. Reinstall door on dryer

Using a Torx® T25 screwdriver, remove the 4 screws on the dryer. Insert the tabs on the hinge into the mounting slot and slide down to engage the top tab. Secure in place with

the 4 Torx® T25 screws removed earlier.

† ® TORX is a registered trademark of Saturn Fasteners, Inc.

22

Image 22
Contents Electric Dryer Installation Instructions Dryer Safety Tools needed Installation RequirementsIf using a power supply cord Parts suppliedInstallation Clearances Location RequirementsElectrical Requirements Prepare dryer for leveling legs Install Leveling LegsIf connecting by direct wire Screw in leveling legsFor power supply cord installations Electric InstallationFor direct wire installations Prepare to connect neutral ground wire and neutral wire Power Supply Cord ConnectionAttach power supply cord Connect neutral ground wire and neutral wireConnect neutral wire Connect ground wireConnect remaining wires Remove center screwAttach direct wire cable to strain relief Direct Wire ConnectionDirect wire strain relief Attach direct wire strain relief Wire Direct Wire ConnectionPrepare your 3-wire cable for direct connection Wire Direct Wire ConnectionConnect external ground wire Optional External Ground for 3-Wire ConnectionPower Supply Cord Shown Venting Venting Requirements Special provisions for mobile homes Plan Vent SystemDetermine vent path Install Vent System Connect Inlet HoseTurn on cold water faucet Attach long hose to Y connector and tighten couplingsAttach long hose to dryer fill valve and tighten coupling Check for leaksConnect vent Level dryerComplete Installation ChecklistRemove door from dryer Door Reversal optionalMove the door strike Remove inner door from outer doorRemove outer window assembly from trim ring Reverse outer window assemblyReinstall hinge and latch on opposite sides Rotate and reassemble outer window assembly to trim ringRemove hinge and latch Reinstall inner door assembly Reinstall door on dryerPage 2010 11/10 All rights reserved