JVC LVT0858-001A Setting the Auto Function Mode, Press Control 3 or 2 to select AUTO1 or AUTO2

ON : The AUTO SR indicator lights up on the display.

•If multichannel signals come in, an appropriate Surround mode will be turned on.

•If Dolby Digital 2ch or DTS 2ch signals including surround signals come in, “PL II MOVIE” will be selected.

•If Dolby Digital 2ch or DTS 2ch signals not including surround signals come in, “STEREO” will be selected.

•If Linear PCM signals come in, nothing will change.

OFF : Select this to deactivate Auto Surround.

Notes:

•This function does not take effect in the following cases:

–While playing an analogue source.

–While selecting “DGTL D.D.” or “DGTL DTS” as the fixed digital input mode (see pages 13 and 14).

•If Surround mode is automatically activated by Auto Surround, another Surround mode in use will be canceled temporarily. When multichannel digital signals stop coming in, the selected Surround mode is canceled, and the previous Surround mode resumes.

•If you press SURROUND ON/OFF or SURROUND MODE with Auto Surround activated, Auto Surround will be canceled temporarily for the currently selected source.

Auto Surround setting will be restored in the following cases:

–When you turn off and on the unit,

–When you change the source,

–When you change the analogue/digital input, and

–When you reset “AUTO SR” to “ON” again.

To cancel Auto Surround

Repeat steps 1 and 2, then select “OFF” in step 3.

Setting the Auto Function Mode

You can activate Auto Function mode.

•This function takes effect only when the video components and TV are connected to this unit with SCART cables.

•This function takes effect for the following sources—DVD, STB, and VCR.

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

2Press CONTROL ∞ (or 5) repeatedly until

“MODE” (with the current setting)* appears on

the display.

CONTROL

R ΙΙ

SR

ATT VOL

*“MANUAL” is the initial setting. If you have already changed the setting, another mode will be shown.

3Press CONTROL 3 (or 2) to select “AUTO1” or “AUTO2.”

• Each time you press the button, Auto Function mode changes

as follows:

	CONTROL
ANALOG	L	C	R	PR ΙΙ
LPCM	SUBWFR LFE DSP
DOLBY D	LS	S	RS	AUTO SR	VOL
DTS				INPUT ATT

AUTO1 : When a video component is turned on while the unit is on, the unit selects the video component as the source automatically.

The AUTO MODE indicator lights up on the display.

AUTO2 : • When a video component is turned on

–while the unit is off, the unit changes the mode into TV Direct and selects the video component as the source automatically.

–while the unit is on or TV Direct is activated, the unit selects the video component as the source automatically.

•When a video component is turned off

–while TV Direct is activated or the unit is on with one of the video components selected, the unit selects the previously selected video component as the source automatically. (If all the video components are turned off, the unit will be turned off automatically.)

The AUTO MODE indicator lights up on the display.

MANUAL : Select the source manually.

Basic Settings

1Press SETTING.

SETTING	The CONTROL buttons now work for basic
	settings.

Notes:

•When selecting VCR as the source, “AUTO1” or “AUTO2” may not work if you only turn on the VCR. If it happens, you may need to start playback to activate Auto Function mode.

•When video components are selected at the same time, DVD is selected rather than STB and VCR, and STB is selected rather than VCR.

19