Miele WT2789iWPM operating instructions Problems with the load size indicator

Problem solving guide

Problems with the load size indicator

Problem	Possible cause			Remedy
The display indicates	Laundry was left in	To recalibrate the sensor to the
a load of <25% or no	the drum when the	zero setting:
load size is indicated	machine was	– Remove the laundry from the
when the drum is full.	switched off. This		drum.
	has decalibrated the	–	Switch off the machine and
	sensor from the zero		leave the door open.
	setting.
		–	Switch on the machine.
	The load sensor has
		–	Turn the programme selector
	to be recalibrated to
			to Cottons.
	zero after running
		–	Press and hold the Load % /
	the Rinse out fluff
			Detergent % button in until the
	programme.
			following message appears in
			the display: Zero setting OK
The display indicates	The load size sensor	Rotate the drum once. If the
a load of 25%, 50%,	has been	display still indicates a load of
75% or 100% when	decalibrated from	25%, 50%, 75% or 100%,
the drum is empty.	the zero setting.	recalibrate the sensor to zero
		again (see above section).
The following will	The drum door is	– Open the drum door.
appear in the display:	closed.	– Recalibrate the sensor to zero
Zero setting not			again.
possible. Open the
door
The drying	There is very little or no			In future use a timed
programme stops and	laundry in the drum. Drying			drying programme or the
the following	individual garments or items			Warm air timed drying
message appears in	which are already dry can			programme for individual
the display:	also cause the programme			items.
Check load	to be cancelled.
At the end of a drying	The machine has recognised			In future do not exceed
programme the	an overload.			the maximum load.
following message
appears in the
display:
Check load

58