Adding detergent
Powder detergent should be added to compartment j (main wash) and compartment i (pre wash, if selected) at the beginning of each wash cycle. Due to the design of the Miele 1/3 to 1/2 the manufacturer’s recommended amount of detergent is plenty for excel- lent wash results.
Do not use chlorine bleach!
Water is taken in through compartment
jduring the main wash. If your water is extremely hard (above 400 ppm cal- cium carbonate) and compartment j is too small for the amount of detergent needed, a service technician can re- program the machine so that water and detergent can also enter through com- partment i.
For small loads:
–Proportionately reduce the amount of detergent used for each small load.
–Check the wash results and the con- dition of the laundry.
–If the laundry is not clean or if it is gray or hard to the touch, add slightly more detergent the next time you use the machine.
It is important to use the correct amount of detergent, because...
...too little detergent can result in:
–gray laundry
–grease/stains not being removed
–lime deposits on the heating ele- ments and drum (in hard water ar- eas).
...too much detergent can result in:
–excessive foam
–insufficient agitation
–poor cleaning and rinsing results.
Water Softeners
If you wish to use a water softener to cut down on detergent usage in hard water areas:
–add the amount of detergent neces- sary for a soft water area.
–Add the specified amount of water softener according to the manufac- turer’s instructions.
Always add the detergent first, in com- partments i and j followed by the softener, to ensure that both are prop- erly dispensed.
12