Miele W 1930 Leveling the machine, Adjust the four leveling feet as fol- lows

Page 34

INSTALLATION INSTRUCTIONS

Leveling the machine

To ensure smooth operation, it is es- sential that the machine is level.

Failure to level the machine can result in the machine "banging" in the spin cy- cle or "walking" across the floor during operation. Energy and water use will also increase.

Adjust the four leveling feet as fol- lows:

^Tip the machine slightly and place a support, such as a block of wood, underneath it.

BEWARE : The washing machine is heavier than it looks! When tipping the machine, be careful that it does not slip or slide along the floor. Take care not to injure yourself or damage any surrounding furniture.

^Unscrew each of the four feet as much as necessary by turning both the foot 1 as well as the locking ring 2 to the left using a screwdriver (see il- lustration).

^Remove the supports, stand the ma- chine on its feet and check to see if it is level.

Repeat this procedure as often as nec- essary until the machine stands level.

^Once level, hold the foot 1 immobile using a wrench while turning the locking ring 2 to the right using a screwdriver. Turn each locking ring until it is tight against the bottom of the machine frame.

All four locking rings must be tight against the bottom of the machine. In addition, check to see that the feet were not inadvertently un- screwed while tightening the rings. Running a machine that is not level or whose feet are not tight may cause damage to both the machine and its surrounding area.

34

Image 34
Contents Operating instructions Contents Guide to the machine Detergent dispenser drawer Important safety instructions Disposal of the packing material Before using the first timeHelp protect our environment Disposal of an old applianceOptimal usage EconomyBefore washing Preparing the LaundryPrepare the wash load Recommended load sizes are noted below To start a programPress the Door button to open the door Load the machine Close the machine doorAfter washing End of ProgramPClose the drum door To interrupt a program To cancel a programChanging the program sequence To change an incorrectly selected programAdding detergent Adding fabric softener or starch Using the Starch program to dis- pense liquid starchStarch Program selection 11 lbs Pre-wash Available Water plus Gentle wash Lbs Program sequence Final spin Starch Spin Fine rinseGraduated spin WoolensWashing C Textile care symbolsTemperature Conversion Chart Tumble dryPre-wash Additional optionsGentle wash Water plusDelay start/Time remaining indicator Time display HminCleaning the detergent drawer Cleaning and careTo clean the washing machine Pull the drawer out until it stopsCleaning the drain pump and lint trap Cleaning and care Cleaning the water inlet filters To clean the filter in the intake hoseProblem solving guide What to do if Cause RemedyOn indicator Indicator lamp isIndicator lamp is flash Pre-washFlows slowly into the ma Chine? Large residues Spite of adequateWater supply, the water Detergent remainLaundry? Grey greasy partiCles cling to washed Liquid detergentOpening the drum door in the event of a power failure Door hinged right Door hinged leftAfter sales service Installation Installation surfaceRemoving the shipping struts Installation Instructions Adjust the four leveling feet as fol- lows Leveling the machineBuilding Washer / Dryer StackDecor panel dimensions Replacing the decor panelInstalling a cabinet matching toekick Water hardness reminder Drain connection Plumbing ConnectionsPlease note Electrical connection Grounding InstructionsProgrammable functions Step SecondsHigh water level Program Lock Child safety featureDesired function 5th rinse cycleAdditional rinse in Rapid wash Deleting the additional func- tions To check if the function has been storedPerform Steps 1 to Technical data DimensionsProgram duration approximate SpecificationsTemperature control Spin speed Detergent dispenser