Cleaning and care
Then flush the unit through from the front.
Check the condenser unit again for any visible fluff and if necessary flush it through again until it has all gone.
Repeat as required.
Also make sure the rubber seals are clean.
The rubber seals must not be removed and must be free of kinks.
Shake the water off the condenser unit until no more droplets of water are visible.
Checking and cleaning the condenser unit housing
Remove any soiling still visible inside the housing unit by hand using a damp cloth. Do not try and access areas you cannot reach by hand!
Replacing the condenser unit
With the handle facing upwards, push the condenser unit back into position in its housing.
Turn the lever down to the horizontal position, making sure that the hook on the lever clicks into the groove.
When replacing the inner cover after cleaning, ensure that the rubber seal fits correctly into the groove.
Replace the inner cover making sure the hooks locate correctly. Hold it at an angle and push it gently downwards.
Then turn the lever upwards into the horizontal position to lock the cover.
Replace the service panel and press the upper edge until it clicks into position.
It is important to ensure that both the condenser unit and the cover are correctly positioned and locked, otherwise water may leak from the dryer.
32