AEG L 75270 FL, L 75670 FL, L 75470 FL user manual Inlet Hose Filter, Valve Filter, Emergency Drain

Page 25

2

1

ENGLISH 25

9.Clean the filter under the water tap and put it back in the pump into the special guides.

10.Make sure that you tighten correct- ly the filter to prevent leakages.

11.Put the flap back and close the drain pump door.

	THE INLET HOSE FILTER AND	• The indicator of button	4	flashes
	THE VALVE FILTER	and the display shows the		related
	It could be necessary to clean the filters	alarm. Refer to 'Troubleshooting'.
		WARNING!
	when:
		Disconnect the mains plug from
	• The appliance does not fill with wa-
		the mains socket.
	ter.

•The appliance fills with the water for a long time.

To clean the water inlet filters:

1. Close the water tap.

2. Remove the water inlet hose from the water tap.

3. Clean the filter in the inlet hose with a stiff brush.

4. Remove the inlet hose behind the appliance.

5. Clean the filter in the valve with a stiff brush or a towel.

45°

35°

6.Install again the inlet hose. Make sure that the couplings are tight to prevent leakages.

7.Open the water tap.

EMERGENCY DRAIN

Because of a malfunction, the appliance cannot drain the water.

If this occurs, do steps (1) through (6) of 'To clean the drain pump'.

If necessary, clean the pump.

Put the drainage duct back and close the drain pump flap.

Image 25

Contents FL L 75470 FL L 75670 FL Service ContentsFor Perfect Results Accessories and ConsumablesVisit OUR Website for Child Safety Device Safety InformationGeneral Safety Care and CleaningDiscard the Appliance Water connectionPackaging Materials Environment ConcernsEcological Hints Interest of the EnvironmentIPX4 Technical InformationProduct Description AccessoriesON/OFF Button Control PanelProgramme Knob DisplayTime Save Button Delay Start ButtonAcoustic Signals Function Temperature ButtonExtra Rinse Button Stain ButtonProgrammes Extra RINSE4 Programme Energy consumption Water consump Consumption ValuesBefore First USE Using the ApplianceLoading the Laundry Check the position of the flap Filling the Detergent and AdditivesCancel a Programme Setting and Starting a ProgrammeInterrupt a Programme Cancel the Delay Start SET the Delay StartAT the END of the Programme Change a FunctionEnglish Laundry Load Helpful Hints and TipsStubborn Stains Detergents and AdditivesWater hardness Mmol/l Clarke Care and Cleaning Drain Pump Detergent DispenserPage Valve Filter Inlet Hose FilterEmergency Drain Frost Precautions Problem Possible cause Possible solution TroubleshootingDelay start is set Problem Possible cause Possible solution Unpacking InstallationPull out the plastic spacers Positioning and Levelling Inlet Hose Installation on a not hard floorWater Drainage Water-stop deviceEnglish 132939750-A-112011