AEG L 75470 FL, L 75670 FL, L 75270 FL user manual Problem Possible cause Possible solution

Page 29

		ENGLISH 29

Problem	Possible cause	Possible solution
The appliance fills	The end of the drain	Make sure that the drain hose is
with water and	hose is too low.	in the correct position.
drain immediately.
The washing re-	The detergent you used	Increase the detergent quantity
sults are not satis-	was not sufficient or cor-	or use a different one.
factory.	rect.

You did not remove the stubborn stains before you wash the laundry.

Use special products to remove the stubborn stains.

Incorrect temperature	Make sure that you set the cor-
was set.	rect temperature.
Too much laundry load.	Decrease the laundry load.

After the check, activate the appliance. The programme continues from the point of interruption.

If the problem occurs again, contact the service centre.

If the display shows other alarm codes, contact the service centre.

Image 29

Contents FL L 75470 FL L 75670 FL Service ContentsVisit OUR Website for Accessories and ConsumablesFor Perfect Results Child Safety Device Safety InformationGeneral Safety Care and CleaningDiscard the Appliance Water connectionPackaging Materials Environment ConcernsEcological Hints Interest of the EnvironmentIPX4 Technical InformationProduct Description AccessoriesON/OFF Button Control PanelProgramme Knob DisplayTime Save Button Delay Start ButtonAcoustic Signals Function Temperature ButtonExtra Rinse Button Stain ButtonProgrammes Extra RINSE4 Programme Energy consumption Water consump Consumption ValuesLoading the Laundry Using the ApplianceBefore First USE Check the position of the flap Filling the Detergent and AdditivesInterrupt a Programme Setting and Starting a ProgrammeCancel a Programme Cancel the Delay Start SET the Delay StartAT the END of the Programme Change a FunctionEnglish Laundry Load Helpful Hints and TipsStubborn Stains Detergents and AdditivesWater hardness Mmol/l Clarke Care and Cleaning Drain Pump Detergent DispenserPage Emergency Drain Inlet Hose FilterValve Filter Frost Precautions Problem Possible cause Possible solution TroubleshootingDelay start is set Problem Possible cause Possible solution Unpacking InstallationPull out the plastic spacers Positioning and Levelling Inlet Hose Installation on a not hard floorWater Drainage Water-stop deviceEnglish 132939750-A-112011