AEG 86810 manual Washing, Starting a programme, Programme progress

Page 19

Starting a programme

1.Check that the water tap is open.

2.Press the START/PAUSE key.

The programme is started or it starts after the time delay set has elapsed.

3If after pressing the START/PAUSE key the display shows “Door not Closed”, the door has not been shut properly. Push the door firmly closed and press the START/PAUSE key again.

Programme progress

The display indicates the stage of the programme that is currently being performed as well as the time to the end of the programme.

LINEN/EASY CARE		12.45
Washing		14.37
50C 800	aýýýýýaýaýaýaýaýaýaýaýa

TEMP.	RPM OPTIONS OK	TIME

3During the wash cycle the

time to the end of the pro- gramme may change as the

programme adjusts itself to different conditions (e. g., type and quanti- ty of laundry, out of balance spin detection, special rinses, etc.).

Interrupting a programme/Adding washing

Interrupting a programme

•The programme can be interrupted at any time by pressing

the START/PAUSE key. It is then re-started by pressing the key again.

•To stop the washing machine before the programme has ended, turn the programme knob to OFF.

Attention! Be careful if there is water in the appliance!

Adding washing

1.Press the START/PAUSE key.

•If “Door locked” and “Pause” are alternately shown in the display, it is no longer possible to add washing, e. g. when the water level is too high.

•If “Door openable” and “Pause” are alternately shown in the display, it is still possible to add washing:

2.Open the door.

3.Add washing and close the door again.

4.Press the START/PAUSE key again. The programme continues.

19

Image 19

Contents Lavamat Dear Customer Following symbols are used in the textContents Safety information concerning installation Installation and connection instructionsGeneral safety SafetyPrior to using the appliance for the first time Child safetyResulting overheating may constitute a fire hazard Cycle end at What is shown in the displayEasy Iron Program overviewUse/Features Care Symbols1 Programmende um Prior to using for the first timeN g u a g e R a c h ePreparing washing Setting the timePreparing and sorting washing Carrying out a wash programme prior to first useOpening the door/Loading the washing Running a wash cycleAdding detergent/conditioner If you are using liquid detergent Switching on the appliance/selecting a programmeWashing powder/tablets for the main wash cycle Speed or Rinse Hold is displayed Changing spin speed/selecting rinse holdWith spin speed 0 the TEMP. RPM Options OK Time Setup Setting optionsPrewash, Sensitive, Stain, Night Cycle To switch off the optionPrewashing SensitiveTime Saving Short or Very Short Setting timesDelay Start Time savingPress the OK key. Start in 0 min is shown in the display Delay StartStart in 4h StartInterrupting a programme/Adding washing WashingStarting a programme Programme progressWashing cycle complete/Removing the washing SetupIf Rinse Hold or Night Cycle was selected Changing the Memory Setting the MemoryMemory Store program Memory 1, 2N s e + U n dExtra Rinse Language Set timeClock Each press of the key or if Child safety deviceDesired setting. With Contrast and brightnessDetergent dispenser drawer Cleaning and maintenanceCleaning procedure Deactivating the child safety deviceTop of the washing-in chamber, with a brush Clean the glass in the door and the rubber collar regularlyWashing drum Door and rubber collarRemedying small malfunctions What to do ifAdjusted There are white residues on the washing If the wash result is not satisfactoryThere are grey stains on the washing Foam can still be seen following the final rinseCarrying out an emergency drain When the water has all drained awayDrain pump Packaging material DisposalOld appliance Consumption values Technical dataThis washing machine cannot be built-in Safety information concerning installationInstalling the appliance Transporting the applianceOnly use the sack trolley on the side of the appliance When using a sack trolley to transport the washing machineRemove the power supply cable UnpackingPage Where to install Making the appliance level Electrical ConnectionPermanent Connection Brown Live Wire coloured green and yellowOpen the porthole and extract the inlet hose Connecting to the water supplyPermitted water pressure Water inletWater Drainage For drainage into an outlet Pumping heights of over 1 metreGreat Britain Guarantee/Customer ServiceEuropean Guarantee LU4 9QQ Slovenija Major Appliances 0870 5 929Customer Care For general enquiries concerning132 977 Subject to change without notice