AEG 86810 manual Water Drainage

Page 41

4.Connect the hose to a tap with a

3/4” thread.

Always use the hose supplied with the appliance.

Water Drainage

The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic “U-Piece“ supplied. The standpipe should have an internal diameter of approximately 38 mm (see dia- gram) thus ensuring there is an air break between the drain hose and standpipe.

Important! It is essential to lay the drainage hose without kinks. When discharging into a stand-

pipe ensure that the top of the curve in the hose end is no more than 90 cm (35.4’’) and no less than 60 cm (23.6’’) above floor level.

The upright standpipe should have a minimum, length of 30 cm (12’’) from the bottom of the el- bow to the top of the pipe (see diagram). Make sure that it is de- signed in such a way that the end of the drain hose cannot be cov- ered with water.

Longer drain hoses are available in lengths of 2.7 and 4 metres from your Service Force Centre.

Image 41

Contents Lavamat Dear Customer Following symbols are used in the textContents Safety information concerning installation Installation and connection instructionsPrior to using the appliance for the first time SafetyChild safety General safetyResulting overheating may constitute a fire hazard Cycle end at What is shown in the displayEasy Iron Program overviewUse/Features Care Symbols1 N g u a g e Prior to using for the first timeR a c h e Programmende umPreparing and sorting washing Setting the timeCarrying out a wash programme prior to first use Preparing washingAdding detergent/conditioner Running a wash cycleOpening the door/Loading the washing Washing powder/tablets for the main wash cycle Switching on the appliance/selecting a programmeIf you are using liquid detergent With spin speed 0 the TEMP. RPM Options OK Time Changing spin speed/selecting rinse holdSpeed or Rinse Hold is displayed Setup Setting optionsPrewashing To switch off the optionSensitive Prewash, Sensitive, Stain, Night CycleDelay Start Setting timesTime saving Time Saving Short or Very ShortStart in 4h Delay StartStart Press the OK key. Start in 0 min is shown in the displayStarting a programme WashingProgramme progress Interrupting a programme/Adding washingIf Rinse Hold or Night Cycle was selected SetupWashing cycle complete/Removing the washing Memory Store program Setting the MemoryMemory 1, 2 Changing the MemoryExtra Rinse U n dN s e + Clock Set timeLanguage Desired setting. With Child safety deviceContrast and brightness Each press of the key or ifCleaning procedure Cleaning and maintenanceDeactivating the child safety device Detergent dispenser drawerWashing drum Clean the glass in the door and the rubber collar regularlyDoor and rubber collar Top of the washing-in chamber, with a brushRemedying small malfunctions What to do ifAdjusted There are grey stains on the washing If the wash result is not satisfactoryFoam can still be seen following the final rinse There are white residues on the washingCarrying out an emergency drain When the water has all drained awayDrain pump Old appliance DisposalPackaging material Consumption values Technical dataInstalling the appliance Safety information concerning installationTransporting the appliance This washing machine cannot be built-inRemove the power supply cable When using a sack trolley to transport the washing machineUnpacking Only use the sack trolley on the side of the appliancePage Where to install Making the appliance level Electrical ConnectionPermanent Connection Brown Live Wire coloured green and yellowPermitted water pressure Connecting to the water supplyWater inlet Open the porthole and extract the inlet hoseWater Drainage For drainage into an outlet Pumping heights of over 1 metreGreat Britain Guarantee/Customer ServiceEuropean Guarantee LU4 9QQ Slovenija Customer Care 0870 5 929For general enquiries concerning Major Appliances132 977 Subject to change without notice