AEG 86810 manual If the wash result is not satisfactory, There are grey stains on the washing

Problem	Possible cause	Remedy
		Wait until the display alternate-
	Door locked.	ly shows “Door openable” and
		“Cycle ended”.
The door cannot be opened	There has been a power	The programme will continue
		when the power cut is over.
when the appliance is	cut. (All displays are off.)
switched on.		To remove washing:
	For safety reasons, the
	door will remain locked	If water can be seen in the ap-
	for between 4 and 10	pliance, before opening the
	minutes.	door, first perform an emergen-
		cy drain.
Washing is heavily creased.	Possibly too much	Observe maximum loads.
	washing was loaded.

If the wash result is not satisfactory

The washing is grey and there are limescale deposits in the drum

•Too little detergent was used.

•An incorrect detergent was used.

•Individual stains were not pre-treated.

•The programme or temperature was not set properly.

There are grey stains on the washing

•Items that were soiled with ointments, fats or oils were washed using too little detergent.

•The wash temperature used was too low.

•A common cause is that conditioner – in particular the type in con- centrated form - has come in contact with the washing. Wash out such marks as soon as possible and exercise care when using the said conditioner.

Foam can still be seen following the final rinse

•Modern detergents can cause foam to be created even during the fi- nal rinse. In spite of this, the washing has been sufficiently rinsed.

There are white residues on the washing

•What can be seen here are insoluble substances which modern deter- gents contain. They are not the result of insufficient rinsing.

Shake or brush the washing. If possible turn the washing inside out before washing. Check your choice of detergent. Especially with dark colours it is advisable to use liquid detergents.

29