AEG 86810 manual Unpacking, When using a sack trolley to transport the washing machine

Page 35

•Do not lay the washing machine on its front nor on its right side (as seen from the front). Electrical components may get wet.

•Never transport the appliance without using the transport lock. Only remove the transport lock when the appliance is in its place of instal- lation. Transporting the appliance without the use of the transport lock can cause damage to the appliance.

•Never lift the appliance by the door when it is open nor by the plinth.

When using a sack trolley to transport the washing machine:

•Only use the sack trolley on the side of the appliance.

Unpacking

1The transport safeguard must be removed before putting the appliance into operation.

Important!

You are advised to keep all the packaging for re-use in case the machine is to be transported again.

1.After removing all the packaging,

with assistance carefully lay ma- chine on it’s back to remove the pol- ystyrene base from the bottom.

2.Remove the power supply cable and

the draining hose from the hose holders on the rear of the appliance.

35

Image 35

Contents Lavamat Dear Customer Following symbols are used in the textContents Safety information concerning installation Installation and connection instructionsGeneral safety SafetyPrior to using the appliance for the first time Child safetyResulting overheating may constitute a fire hazard Cycle end at What is shown in the displayEasy Iron Program overviewUse/Features Care Symbols1 Programmende um Prior to using for the first timeN g u a g e R a c h ePreparing washing Setting the timePreparing and sorting washing Carrying out a wash programme prior to first useAdding detergent/conditioner Running a wash cycleOpening the door/Loading the washing Washing powder/tablets for the main wash cycle Switching on the appliance/selecting a programmeIf you are using liquid detergent With spin speed 0 the TEMP. RPM Options OK Time Changing spin speed/selecting rinse holdSpeed or Rinse Hold is displayed Setup Setting optionsPrewash, Sensitive, Stain, Night Cycle To switch off the optionPrewashing SensitiveTime Saving Short or Very Short Setting timesDelay Start Time savingPress the OK key. Start in 0 min is shown in the display Delay StartStart in 4h StartInterrupting a programme/Adding washing WashingStarting a programme Programme progressIf Rinse Hold or Night Cycle was selected SetupWashing cycle complete/Removing the washing Changing the Memory Setting the MemoryMemory Store program Memory 1, 2Extra Rinse U n dN s e + Clock Set timeLanguage Each press of the key or if Child safety deviceDesired setting. With Contrast and brightnessDetergent dispenser drawer Cleaning and maintenanceCleaning procedure Deactivating the child safety deviceTop of the washing-in chamber, with a brush Clean the glass in the door and the rubber collar regularlyWashing drum Door and rubber collarRemedying small malfunctions What to do ifAdjusted There are white residues on the washing If the wash result is not satisfactoryThere are grey stains on the washing Foam can still be seen following the final rinseCarrying out an emergency drain When the water has all drained awayDrain pump Old appliance DisposalPackaging material Consumption values Technical dataThis washing machine cannot be built-in Safety information concerning installationInstalling the appliance Transporting the applianceOnly use the sack trolley on the side of the appliance When using a sack trolley to transport the washing machineRemove the power supply cable UnpackingPage Where to install Making the appliance level Electrical ConnectionPermanent Connection Brown Live Wire coloured green and yellowOpen the porthole and extract the inlet hose Connecting to the water supplyPermitted water pressure Water inletWater Drainage For drainage into an outlet Pumping heights of over 1 metreGreat Britain Guarantee/Customer ServiceEuropean Guarantee LU4 9QQ Slovenija Major Appliances 0870 5 929Customer Care For general enquiries concerning132 977 Subject to change without notice