AEG 86810 manual What to do if, Remedying small malfunctions

Page 27

What to do if...

Remedying small malfunctions

If while the appliance is operating a short acoustic signal sounds 3 times and one of the following messages appears in the display:

“No incoming water/Check tap & Hose”,

“No drain - check/drain hose/filter” or “Pump Blocked”,

“Door not Closed”,

please have a look at the following table.

When the fault is remedied, press the START/PAUSE key.

If “Warning : E and number or letter” is displayed: Switch the appliance off and on again. Re-set the programme. Press the START/PAUSE key. If the warning is displayed again, please contact the Service Force Centre and inform them of the warning.

Problem

Possible cause

Remedy

 

Mains plug not plugged

Plug in mains plug. Check

 

in or fuse not working.

fuse.

Washing machine does not

Door not closed properly.

Close door - there should be

an audible click.

work.

 

 

 

START/PAUSE key was

Press START/PAUSE key for

 

not pressed for long

 

longer.

 

enough.

 

 

The door cannot be closed.

Child safety device en-

Release the child safety de-

gaged.

vice.

 

 

The selected function

 

Display shows: ”Selection

cannot be combined

Make another selection.

error”.

with other programme

 

 

settings.

 

Display shows: “Door not

Door not closed properly.

Close door - there should be

an audible click.

Closed/Please check”

 

Start programme again.

 

 

 

Tap turned off.

Turn the tap on.

Display shows: “No inco-

The filter in the threaded

Turn off the tap. Unscrew the

inlet hose fitting is

hose, take out the filter and

ming water/Check tap &

blocked.

clean it.

Hose”

 

 

 

Water tap is blocked

Check the water tap and have

 

with limescale or faulty.

it repaired if necessary.

 

 

 

27

Image 27
Contents Lavamat Dear Customer Following symbols are used in the textContents Safety information concerning installation Installation and connection instructionsGeneral safety SafetyPrior to using the appliance for the first time Child safetyResulting overheating may constitute a fire hazard Cycle end at What is shown in the displayEasy Iron Program overviewUse/Features Care Symbols1 Programmende um Prior to using for the first timeN g u a g e R a c h ePreparing washing Setting the timePreparing and sorting washing Carrying out a wash programme prior to first useRunning a wash cycle Opening the door/Loading the washingAdding detergent/conditioner Switching on the appliance/selecting a programme If you are using liquid detergentWashing powder/tablets for the main wash cycle Changing spin speed/selecting rinse hold Speed or Rinse Hold is displayedWith spin speed 0 the TEMP. RPM Options OK Time Setup Setting optionsPrewash, Sensitive, Stain, Night Cycle To switch off the optionPrewashing SensitiveTime Saving Short or Very Short Setting timesDelay Start Time savingPress the OK key. Start in 0 min is shown in the display Delay StartStart in 4h StartInterrupting a programme/Adding washing WashingStarting a programme Programme progressSetup Washing cycle complete/Removing the washingIf Rinse Hold or Night Cycle was selected Changing the Memory Setting the MemoryMemory Store program Memory 1, 2U n d N s e +Extra Rinse Set time LanguageClock Each press of the key or if Child safety deviceDesired setting. With Contrast and brightnessDetergent dispenser drawer Cleaning and maintenanceCleaning procedure Deactivating the child safety deviceTop of the washing-in chamber, with a brush Clean the glass in the door and the rubber collar regularlyWashing drum Door and rubber collarRemedying small malfunctions What to do ifAdjusted There are white residues on the washing If the wash result is not satisfactoryThere are grey stains on the washing Foam can still be seen following the final rinseCarrying out an emergency drain When the water has all drained awayDrain pump Disposal Packaging materialOld appliance Consumption values Technical dataThis washing machine cannot be built-in Safety information concerning installationInstalling the appliance Transporting the applianceOnly use the sack trolley on the side of the appliance When using a sack trolley to transport the washing machineRemove the power supply cable UnpackingPage Where to install Making the appliance level Electrical ConnectionPermanent Connection Brown Live Wire coloured green and yellowOpen the porthole and extract the inlet hose Connecting to the water supplyPermitted water pressure Water inletWater Drainage For drainage into an outlet Pumping heights of over 1 metreGreat Britain Guarantee/Customer ServiceEuropean Guarantee LU4 9QQ Slovenija Major Appliances 0870 5 929Customer Care For general enquiries concerning132 977 Subject to change without notice