Smeg TLS6 Appliance exterior and control panel, Appliance interior, Lid seal, Water inlet hoses

Page 11

Appliance exterior and control panel

•Clean with a soft damp cloth.

•If necessary, a neutral household cleaner can be applied (do not use aggressive or abrasive products).

Appliance interior

•After each washing, leave the lid open for some time to allow the inside of the appliance to dry.

•If you never or seldom wash your laundry at 95°C, we recommend to occasionally run a 95°C programme without laundry, adding a small amount of detergent, to keep the interior of the appliance clean.

Lid seal

•Check the condition of the lid seal periodically and clean it from time to time with a damp cloth.

Water inlet hose(s)

•Check the hose regularly for brittleness and cracks. Replace if necessary.

Filter

•Check and clean the filter regularly, at least 3 or 4 times a year (see “Cleaning the Filter/ Draining Residual Water”).

Do not use flammable fluids for cleaning the appliance.

Recovering an object that falls between the drum and the tub

If an object accidentally falls between the drum and the tub, you can recover it thanks to one of the removable drum blades:

1.Unplug the washing machine.

2.Remove the laundry from the drum.

3.Close the drum flaps and turn the drum a half-turn.

4.Using a screw-driver, press on the plastic end while sliding the blade from left to right.

5.It will fall into the drum.

6.Open the drum: you can recover the object through the hole in the drum.

7.Refit the blade from inside the drum:

Position the plastic tip above the hole on the right side of the drum.

8.Then slide the plastic blade from right to left until it clips.

9.Close the drum flaps again, turn the drum through half a turn and check the positioning of the blade at all its anchorage points.

10.Plug the washing machine in again.

3

4

4

7

GB 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Contents Water supply Install the washing machineRemove the packaging and check Remove the transport bracketEnergy saving tips Safety instructions EC Declaration of ConformityPacking Disposing of packaging and old washing machinesBefore the First Wash Cycle Adjustable feetDescription of the Washing Machine Dyeing and bleaching Preparation of the WashingSort the laundry Stain removalLoading the laundry Do not use solvents turpentine, benzine, etc Detergents and AdditivesChoice of the right detergents and additives DosageUsing starch powder Where to put detergents and additivesUsing chlorine bleach Cleaning the FILTER/ Draining Residual Water Water inlet hose Detergent dispenserWater inlet hose filter Water inlet hoses Appliance exterior and control panelAppliance interior Lid sealTroubleshooting Guide Description of red indications Red indication lamp Indication on Description Specify AFTER-SALES ServiceBefore contacting After-Sales Service Transport and HandlingRemoval of transport bracket InstallationConnect the water inlet hose Adjust the feetFix the U bend C at the very end of the drain hose Water stop anti-flooding systemConnect the water drain hose Is the risk of leakage and of scalding with hot waterPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A Brown Live LTo fit a new plug, proceed as follows
Top Page Image Contents