Smeg TLS8, TLS6 Description of the Washing Machine, Before the First Wash Cycle, Adjustable feet

Page 4

DESCRIPTION OF THE WASHING MACHINE

1.Lid

2.Detergent dispenser

3.Drum

4.Pump access behind filter

5.After-Sales Service sticker (behind the filter cover)

6.Mobility lever (depending on model)

• To move the washing machine: pull the handle out a little bit by hand and pull it out to the stop with the foot.

To remove any residual water used in testing by the manufacturer, we recommend that you carry out a short wash cycle without laundry.

1.Open the tap.

2.Close the drum flaps.

3.Pour a small amount of detergent (about 30 ml) into the main wash chamber of the detergent dispenser.

4.Close the lid.

5.Select and start a short programme (see separate programme chart).

GB 4

Image 4

Contents Contents Install the washing machine Remove the packaging and checkRemove the transport bracket Water supplySafety instructions EC Declaration of Conformity PackingDisposing of packaging and old washing machines Energy saving tipsDescription of the Washing Machine Adjustable feetBefore the First Wash Cycle Preparation of the Washing Sort the laundryStain removal Dyeing and bleachingLoading the laundry Detergents and Additives Choice of the right detergents and additivesDosage Do not use solvents turpentine, benzine, etcUsing chlorine bleach Where to put detergents and additivesUsing starch powder Cleaning the FILTER/ Draining Residual Water Water inlet hose filter Detergent dispenserWater inlet hose Appliance exterior and control panel Appliance interiorLid seal Water inlet hosesTroubleshooting Guide Description of red indications Red indication lamp Indication on Description AFTER-SALES Service Before contacting After-Sales ServiceTransport and Handling SpecifyInstallation Removal of transport bracketAdjust the feet Connect the water inlet hoseWater stop anti-flooding system Connect the water drain hoseIs the risk of leakage and of scalding with hot water Fix the U bend C at the very end of the drain hoseTo fit a new plug, proceed as follows Brown Live LPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A