Description of red indications
Red indication lamp | Indication on display | Description | |
(if fitted on your | Causes | ||
lights up | |||
machine) | Solutions | ||
| |||
|
|
| |
|
| Appliance has no or insufficient water supply. The | |
|
| “Start/Pause” light flashes. | |
|
| Check whether: | |
|
| • Water tap is fully open and water supply pressure | |
|
| is sufficient. | |
|
| • Kinks are present in water inlet hose. | |
|
| • Mesh filter of water supply hose is blocked (see | |
|
| “Care and Maintenance”. | |
|
| • Water hose is frozen up. | |
“Water tap closed” |
| • Safety valve inspection window of your water | |
|
| supply hose is red (provided your appliance has a | |
|
| water supply hose as shown on picture “A” - see | |
|
| previous chapter “Care and Maintenance”); | |
|
| replace the hose by a new one available through | |
|
| our | |
|
| After problem has been removed, restart | |
|
| programme by pressing “Start/Pause”. If the fault | |
|
| occurs again, contact our | |
|
| next chapter). | |
|
|
| |
|
| Waste water is not pumped out. The appliance | |
|
| stops in the corresponding programme step; unplug | |
|
| it and check whether: | |
|
| • Kinks are present in the drain hose. | |
|
| • Filter or pump is blocked (see chapter “Cleaning | |
|
| the Filter/ Draining Residual Water”; make sure | |
|
| the water has cooled before draining the | |
“Clean pump” |
| appliance). | |
| • The drain hose is frozen up. | ||
|
| ||
|
| After problem has been removed, select and start | |
|
| “Drain” programme or push “Reset” button for at | |
|
| least 3 seconds; afterwards restart desired | |
|
| programme. If the fault occurs again, contact our | |
|
| ||
|
|
|
GB 13