Smeg TLS6 AFTER-SALES Service, Transport and Handling, Before contacting After-Sales Service

Page 15

AFTER-SALES SERVICE

Before contacting After-Sales Service:

1.Try to remedy the problem yourself (see “Troubleshooting Guide”).

2.Restart the programme to check whether the problem has solved itself.

3.If the machine continues to function incorrectly, call After-Sales Service.

Specify:

•The nature of the problem.

•The exact model of the washing machine.

•The service code (number after the word SERVICE).

The After-Sales Service sticker is situated behind the filter cover or on the rear of the machine.

•Your full address.

•Your telephone number and area code.

As a priority, you should contact the After-Sales Service of the retailer who supplied you with the washing machine.

TRANSPORT AND HANDLING

1.Unplug the washing machine.

2.Turn off the tap.

3.Remove the water supply and drain hose.

4.Eliminate all water from the hoses and the washing machine (see “Cleaning the Filter/ Draining Residual Water”).

Wait for the water to cool so as to avoid any accidents.

5.To facilitate moving the machine, pull the handle situated at the bottom front (if available on your model) out a little by hand and pull it out to the stop with the foot. Afterwards push the handle back into the original stable position.

6.Fix the transport bracket again for transportation.

7.Transport the washing machine upright.

IMPORTANT: Do not use the washing machine while the handle is pulled out.

GB 15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Contents Water supply Install the washing machineRemove the packaging and check Remove the transport bracketEnergy saving tips Safety instructions EC Declaration of ConformityPacking Disposing of packaging and old washing machinesAdjustable feet Description of the Washing MachineBefore the First Wash Cycle Dyeing and bleaching Preparation of the WashingSort the laundry Stain removalLoading the laundry Do not use solvents turpentine, benzine, etc Detergents and AdditivesChoice of the right detergents and additives DosageWhere to put detergents and additives Using chlorine bleachUsing starch powder Cleaning the FILTER/ Draining Residual Water Detergent dispenser Water inlet hose filterWater inlet hose Water inlet hoses Appliance exterior and control panelAppliance interior Lid sealTroubleshooting Guide Description of red indications Red indication lamp Indication on Description Specify AFTER-SALES ServiceBefore contacting After-Sales Service Transport and HandlingRemoval of transport bracket InstallationConnect the water inlet hose Adjust the feetFix the U bend C at the very end of the drain hose Water stop anti-flooding systemConnect the water drain hose Is the risk of leakage and of scalding with hot waterBrown Live L To fit a new plug, proceed as followsPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A
Top Page Image Contents