Smeg TLS6, TLS8 manual Brown Live L, To fit a new plug, proceed as follows

Page 19

ELECTRICAL CONNECTION

Do not use extension leads or multi sockets.

Electrical connections must be made in accordance with local regulations.

1) Warning - this washing machine must be earthed

This washing machine is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity.

If the fitted plug is not suitable for your socket outlet, or if the machine’s mains lead is not fitted with a plug, you should fit a suitable new, good quality plug by following the instructions in (2) below.

Any unsuitable plug should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a socket.

2)CONNECTION TO A REWIRABLE PLUG - to be carried out only by a qualified electrician The wires in the mains lead are coloured in accordance with the following code:

BLUE - “NEUTRAL” (“N”)

BROWN - “LIVE” (“L”)

GREEN AND YELLOW - “EARTH” (“E”)

To fit a new plug, proceed as follows:

2.1Polarized Plugs (e.g. 3 pin, 13 amp plug conforming to BS 1363A)

a.The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by

the Earth symbol

or coloured green and yellow.

b.The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured blue.

c.The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured brown.

2.2) Non-polarized plugs (e.g. 2 pin with side earth contact)

The wire which is coloured GREEN AND YELLOW must be connected to the earth contact. The other two wires should be connected to the two pins, irrespective of colour.

FUSE REPLACEMENT

If the mains lead of this washing machine is fitted with a BS 1363A 13 amp fused plug, replace the fuse only with an A.S.T.A. approved type conforming to BS 1362 and proceed as follows:

Remove the fuse cover (A) and the fuse (B).

Fit the replacement 13 A fuse into the fuse cover. Refit both into the plug.

For all other types of plug, the supply socket should be protected by a 16 A fuse or circuit breaker at the distribution board.

GB 19

Page 18 Page 19
Image 19
Page 18 Page 19
Contents Contents Water supply Install the washing machineRemove the packaging and check Remove the transport bracketEnergy saving tips Safety instructions EC Declaration of ConformityPacking Disposing of packaging and old washing machinesDescription of the Washing Machine Adjustable feetBefore the First Wash Cycle Dyeing and bleaching Preparation of the WashingSort the laundry Stain removalLoading the laundry Do not use solvents turpentine, benzine, etc Detergents and AdditivesChoice of the right detergents and additives DosageUsing chlorine bleach Where to put detergents and additivesUsing starch powder Cleaning the FILTER/ Draining Residual Water Water inlet hose filter Detergent dispenserWater inlet hose Water inlet hoses Appliance exterior and control panelAppliance interior Lid sealTroubleshooting Guide Description of red indications Red indication lamp Indication on Description Specify AFTER-SALES ServiceBefore contacting After-Sales Service Transport and HandlingRemoval of transport bracket InstallationConnect the water inlet hose Adjust the feetFix the U bend C at the very end of the drain hose Water stop anti-flooding systemConnect the water drain hose Is the risk of leakage and of scalding with hot waterTo fit a new plug, proceed as follows Brown Live LPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A
Top Page Image Contents