Smeg TLS12 Where to put detergents and additives, Using chlorine bleach, Using starch powder

Page 10

Where to put detergents and additives

Pour in the detergent:

Washing powder for prewash and main wash

Washing powder for main wash without prewash

Fabric softeners no more than to “MAX” mark.

Stain removers

Water softeners (water hardness class 4)

Starch (dissolved in water; maximum 100 ml)

Be careful not to fill more than the “MAX” level mark.

For programmes without prewash and temperatures from cold to 40° C, it is recommended to use liquid detergents to avoid whitish residues on the laundry.

()

Using chlorine bleach

Wash your laundry in the desired programme (Cotton, Synthetics), adding an appropriate amount of chlorine bleach to the SOFTENER chamber (close the lid carefully).

Immediately after end of programme, start the “Rinse and Spin” programme to eliminate any residual bleach smell; if you want, you can add softener.

Never put both chlorine bleach and softener into the softener chamber at the same time.

Using starch powder

If you want to use starch powder, proceed as follows:

Wash your laundry in the desired wash programme.

Prepare the starch solution according to the starch manufacturer’s instructions.

Fill the prepared starch solution (maximum 100 ml) into the softener chamber of the detergent dispenser.

Close the lid and start programme “Rinse and Spin”.

GB 8

Image 10
Contents Contents Programme Chart Consumption Data Before Using the Washing Machine Precautions and General Recommendations Description of the Washing Machine Adjustable feetBefore the First Wash Cycle Stain removal Preparation of the WashingSort the laundry Dyeing and bleachingLoading the laundry Choice of the right detergents and additives Detergents and AdditivesDosage Using chlorine bleach Where to put detergents and additivesUsing starch powder Cleaning the FILTER/ Draining Residual Water Water inlet hose filter Detergent dispenserWater inlet hose Lid seal Appliance exterior and control panelAppliance interior Water inlet hosesSpin cycle Installation Problem Causes, Solutions, TipsContains residues from Blocked see Care and Maintenance Animation appears during such update periodsDescription Description of red indicationsRed indication lamp Start/Pause light flashesIndication on Description Specify Before contacting After-Sales ServiceWait for the water to cool so as to avoid any accidents Removal of transport bracket Connect the water inlet hose Adjust the feetMake sure there are no kinks in the hose Water stop anti-flooding system Connect the water drain hoseTo fit a new plug, proceed as follows Earth symbolBrown Live L Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363A