Smeg TLS12 manual Adjust the feet, Connect the water inlet hose

Page 19

Adjust the feet

Install the washing machine on a level surface, near to electrical, water and drain connections.

If the floor is uneven, adjust the feet (do not insert pieces of wood, cardboard etc. under the feet):

1.Loosen the locknut using the wrench provided.

2.Adjust the height of the feet by hand.

3.Retighten the locknut by turning it anti-clockwise.

Make sure that the feet are resting correctly on the floor and that the washing machine is perfectly level and stable (use a spirit level).

The washing machine can be installed in an area 40 cm wide and 63 cm deep.

Note: if you install the machine on thick carpet, adjust the feet to ensure that there is sufficient space under the machine for the air to circulate.

Connect the water inlet hose

1.Carefully screw the water inlet hose “A” (see pictures “1” or “2”, depending on model) onto the tap by hand.

2.Make sure there are no kinks in the hose.

3.Check water-tightness of tap and washing machine connections by turning the tap completely on.

If the hose is too short, replace it with a suitable length of pressure resistant hose (minimum 1000 kPa - EN 50084 approved type).

Periodically check the hose for brittleness and cracks. Replace if necessary.

The washing machine can be connected without a non- return valve.

A

1

2

GB 17

Image 19
Contents Contents Programme Chart Consumption Data Before Using the Washing Machine Precautions and General Recommendations Description of the Washing Machine Adjustable feetBefore the First Wash Cycle Dyeing and bleaching Preparation of the WashingSort the laundry Stain removalLoading the laundry Choice of the right detergents and additives Detergents and AdditivesDosage Using chlorine bleach Where to put detergents and additivesUsing starch powder Cleaning the FILTER/ Draining Residual Water Water inlet hose filter Detergent dispenserWater inlet hose Water inlet hoses Appliance exterior and control panelAppliance interior Lid sealAnimation appears during such update periods Problem Causes, Solutions, TipsContains residues from Blocked see Care and Maintenance Spin cycle InstallationStart/Pause light flashes Description of red indicationsRed indication lamp DescriptionIndication on Description Specify Before contacting After-Sales ServiceWait for the water to cool so as to avoid any accidents Removal of transport bracket Connect the water inlet hose Adjust the feetMake sure there are no kinks in the hose Connect the water drain hose Water stop anti-flooding systemPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A Earth symbolBrown Live L To fit a new plug, proceed as follows