Smeg TLS12 manual Description of red indications, Red indication lamp, Start/Pause light flashes

Page 15

Description of red indications

Red indication lamp

Indication on display

Description

 

(if fitted on your

Causes

 

lights up

 

machine)

Solutions

 

 

 

 

 

 

 

 

 

Appliance has no or insufficient water supply. The

 

 

 

“Start/Pause” light flashes.

 

 

 

Check whether:

 

 

 

Water tap is fully open and water supply pressure

 

 

 

is sufficient.

 

 

 

Kinks are present in water inlet hose.

 

 

 

Mesh filter of water supply hose is blocked (see

 

 

 

“Care and Maintenance”.

 

 

 

Water hose is frozen up.

 

“Water tap closed”

 

Safety valve inspection window of your water

 

 

 

supply hose is red (provided your appliance has a

 

 

 

water supply hose as shown on picture “A” - see

 

 

 

previous chapter “Care and Maintenance”);

 

 

 

replace the hose by a new one available through

 

 

 

our After-Sales Service or your specialist dealer.

 

After problem has been removed, restart programme by pressing “Start/Pause”. If the fault occurs again, contact our After-Sales Service (see next chapter).

 

Waste water is not pumped out. The appliance

 

stops in the corresponding programme step; unplug

 

it and check whether:

 

Kinks are present in the drain hose.

 

Filter or pump is blocked (see chapter “Cleaning

 

the Filter/ Draining Residual Water”; make sure

 

the water has cooled before draining the

“Clean pump”

appliance).

The drain hose is frozen up.

 

 

After problem has been removed, select and start

 

“Drain” programme or push “Reset” button for at

 

least 3 seconds; afterwards restart desired

 

programme. If the fault occurs again, contact our

 

After-Sales-Service (see next chapter).

GB 13

Image 15
Contents Contents Programme Chart Consumption Data Before Using the Washing Machine Precautions and General Recommendations Adjustable feet Description of the Washing MachineBefore the First Wash Cycle Dyeing and bleaching Preparation of the WashingSort the laundry Stain removalLoading the laundry Detergents and Additives Choice of the right detergents and additivesDosage Where to put detergents and additives Using chlorine bleachUsing starch powder Cleaning the FILTER/ Draining Residual Water Detergent dispenser Water inlet hose filterWater inlet hose Water inlet hoses Appliance exterior and control panelAppliance interior Lid sealAnimation appears during such update periods Problem Causes, Solutions, TipsContains residues from Blocked see Care and Maintenance Spin cycle InstallationStart/Pause light flashes Description of red indicationsRed indication lamp DescriptionIndication on Description Before contacting After-Sales Service SpecifyWait for the water to cool so as to avoid any accidents Removal of transport bracket Adjust the feet Connect the water inlet hoseMake sure there are no kinks in the hose Connect the water drain hose Water stop anti-flooding systemPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A Earth symbolBrown Live L To fit a new plug, proceed as follows