Smeg TLS12 manual Installation, Removal of transport bracket

Page 18

INSTALLATION

Removal of transport bracket

The washing machine is fitted with a transport bracket to avoid any possible damage during transport.

IMPORTANT: Before using the washing machine, the transport bracket at the back MUST be removed.

1.Unscrew the two screws “A” and the four screws “B” with a flat screwdriver or a No. 8 hex nut box spanner.

2.Remove the transport bracket.

3.Replace the four outer screws “B” on the machine and tighten them.

4.Clip the two seals “C” supplied into the openings “D” of the washing machine.

Note: do not forget to replace and tighten the four outer screws.

AB

D

1

1

1

2

C

4 D

4

GB 16

Image 18
Contents Contents Programme Chart Consumption Data Before Using the Washing Machine Precautions and General Recommendations Adjustable feet Description of the Washing MachineBefore the First Wash Cycle Stain removal Preparation of the WashingSort the laundry Dyeing and bleachingLoading the laundry Detergents and Additives Choice of the right detergents and additivesDosage Where to put detergents and additives Using chlorine bleachUsing starch powder Cleaning the FILTER/ Draining Residual Water Detergent dispenser Water inlet hose filterWater inlet hose Lid seal Appliance exterior and control panelAppliance interior Water inlet hosesSpin cycle Installation Problem Causes, Solutions, TipsContains residues from Blocked see Care and Maintenance Animation appears during such update periodsDescription Description of red indicationsRed indication lamp Start/Pause light flashesIndication on Description Before contacting After-Sales Service SpecifyWait for the water to cool so as to avoid any accidents Removal of transport bracket Adjust the feet Connect the water inlet hoseMake sure there are no kinks in the hose Water stop anti-flooding system Connect the water drain hoseTo fit a new plug, proceed as follows Earth symbolBrown Live L Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363A