Smeg TLS12 Appliance exterior and control panel, Appliance interior, Lid seal, Water inlet hoses

Page 13

Appliance exterior and control panel

Clean with a soft damp cloth.

If necessary, a neutral household cleaner can be applied (do not use aggressive or abrasive products).

Appliance interior

After each washing, leave the lid open for some time to allow the inside of the appliance to dry.

If you never or seldom wash your laundry at 95°C, we recommend to occasionally run a 95°C programme without laundry, adding a small amount of detergent, to keep the interior of the appliance clean.

Lid seal

Check the condition of the lid seal periodically and clean it from time to time with a damp cloth.

Water inlet hose(s)

Check the hose regularly for brittleness and cracks. Replace if necessary.

Filter

Check and clean the filter regularly, at least 3 or 4 times a year (see “Cleaning the Filter/ Draining Residual Water”).

Do not use flammable fluids for cleaning the appliance.

Recovering an object that falls between the drum and the tub

If an object accidentally falls between the drum and the tub, you can recover it thanks to one of the removable drum blades:

1.Unplug the washing machine.

2.Remove the laundry from the drum.

3.Close the drum flaps and turn the drum a half-turn.

4.Using a screw-driver, press on the plastic end while sliding the blade from left to right.

5.It will fall into the drum.

6.Open the drum: you can recover the object through the hole in the drum.

7.Refit the blade from inside the drum:

Position the plastic tip above the hole on the right side of the drum.

8.Then slide the plastic blade from right to left until it clips.

9.Close the drum flaps again, turn the drum through half a turn and check the positioning of the blade at all its anchorage points.

10.Plug the washing machine in again.

3

4

4

7

GB 11

Image 13
Contents Contents Programme Chart Consumption Data Before Using the Washing Machine Precautions and General Recommendations Description of the Washing Machine Adjustable feetBefore the First Wash Cycle Sort the laundry Preparation of the WashingStain removal Dyeing and bleachingLoading the laundry Choice of the right detergents and additives Detergents and AdditivesDosage Using chlorine bleach Where to put detergents and additivesUsing starch powder Cleaning the FILTER/ Draining Residual Water Water inlet hose filter Detergent dispenserWater inlet hose Appliance interior Appliance exterior and control panelLid seal Water inlet hosesContains residues from Blocked see Care and Maintenance Problem Causes, Solutions, TipsSpin cycle Installation Animation appears during such update periodsRed indication lamp Description of red indicationsDescription Start/Pause light flashesIndication on Description Specify Before contacting After-Sales ServiceWait for the water to cool so as to avoid any accidents Removal of transport bracket Connect the water inlet hose Adjust the feetMake sure there are no kinks in the hose Connect the water drain hose Water stop anti-flooding systemBrown Live L Earth symbolTo fit a new plug, proceed as follows Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363A