Smeg TLS12 manual Description of the Washing Machine, Before the First Wash Cycle, Adjustable feet

Page 6

DESCRIPTION OF THE WASHING MACHINE

1.Lid

2.Detergent dispenser

3.Drum

4.Pump access behind filter

5.After-Sales Service sticker (behind the filter cover)

6.Mobility lever (depending on model)

• To move the washing machine: pull the handle out a little bit by hand and pull it out to the stop with the foot.

To remove any residual water used in testing by the manufacturer, we recommend that you carry out a short wash cycle without laundry.

1.Open the tap.

2.Close the drum flaps.

3.Pour a small amount of detergent (about 30 ml) into the main wash chamber of the detergent dispenser.

4.Close the lid.

5.Select and start a short programme (see separate programme chart).

GB 4

Image 6

Contents Contents Programme Chart Consumption Data Before Using the Washing Machine Precautions and General Recommendations Adjustable feet Description of the Washing MachineBefore the First Wash Cycle Stain removal Preparation of the WashingSort the laundry Dyeing and bleachingLoading the laundry Detergents and Additives Choice of the right detergents and additivesDosage Where to put detergents and additives Using chlorine bleachUsing starch powder Cleaning the FILTER/ Draining Residual Water Detergent dispenser Water inlet hose filterWater inlet hose Lid seal Appliance exterior and control panelAppliance interior Water inlet hosesSpin cycle Installation Problem Causes, Solutions, TipsContains residues from Blocked see Care and Maintenance Animation appears during such update periodsDescription Description of red indicationsRed indication lamp Start/Pause light flashesIndication on Description Before contacting After-Sales Service SpecifyWait for the water to cool so as to avoid any accidents Removal of transport bracket Adjust the feet Connect the water inlet hoseMake sure there are no kinks in the hose Water stop anti-flooding system Connect the water drain hoseTo fit a new plug, proceed as follows Earth symbolBrown Live L Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363A