Beko WI 1382 user manual Adjusting the feet, Raising the appliance

Page 10

The hose should be attached to a height of at least 40 cm, and 100 cm at most.

In case the hose is elevated after laying it on the floor level or close to the ground (less than 40 cm above the ground), water discharge becomes more difficult and the laundry may come out excessively wet. Therefore, follow the heights described in the figure.

To prevent flowing of dirty water back into the machine and to allow for easy discharge, do not immerse the hose end into the dirty water or drive it in the drain more than 15 cm. If it is too long, cut it short.

The end of the hose should not be bent, it should not be stepped on and the hose must not be pinched between the drain and the machine.

If the length of the hose is too short, use it by adding an original extension hose. Length of the hose may not be longer than 3.2 m. To avoid water leak failures, the connection between the extension hose and the drain hose of the product must be fitted well with an appropriate clamp as not to come off and leak.

Adjusting the feet

AIn order to ensure that the product operates more silent and vibration- free, it must stand level and balanced on its feet. Balance the machine by adjusting the feet. Otherwise, the product may move from its place and cause crushing and vibration

problems.

1.Loosen the lock nuts on the feet by hand.

2.Adjust the feet until the product stands level and balanced.

3.Tighten all lock nuts again by hand.

ADo not use any tools to loosen the lock nuts. Otherwise, they will get damaged.

Raising the appliance

In order to raise the appliance to eliminate the gap below the worktop, you will need to order special optional kit.

Please call Beko Spare Part Department. (0845 6004911) and see built-in installation section.

Gap

Without optional

With optional raising

raising feet.

feet. Minimum

 

height=55 mm, max Service Ref. No. 1493

 

height=65mm

10

EN

Image 10
Contents Washing Machine Explanation of symbols Table of Contents Your washing machine OverviewTechnical specifications General safety Important safety instructionsIntended use Childrens safety Removing packaging reinforcement InstallationAppropriate installation location Removing the transportation locksConnecting water supply Connecting to the drainAdjusting the feet Raising the applianceElectrical requirements Electrical connectionFitting a different plug Transportation of the product First useDisposing of packaging material Disposing of the old productSorting the laundry PreparationThings to be done for energy saving Preparing laundry for washingCorrect load capacity Loading the laundryDetergent drawer compartments are indicated below Detergents and softenersDetergent Drawer II Main Wash CompartmentBleaches Pre-Wash CompartmentStarch Eliminating lime formationTips for efficient washing Woolens/SilksSelecting a Program and Operating Your Machine Control panelProgram selection Display symbolsTurning the machine on Main programsAdditional programs Special programs Temperature selectionSpin Speed selection Program and consumption table Page Auxiliary functions Time displayStarting the Program Progress of programChanging the selections after the program has started Switching the machine to standby modeChild-proof lock Program in rinse hold mode Ending the program through cancellingEnd of program Maintenance and cleaning Detergent DrawerDraining any remaining water and cleaning the pump filter Into their positions and pushing the upper part of it Troubleshooting Tap is turned off. Open the inlet water taps fullyPage Select the proper temperature for the laundry to be washed Page Use smaller amounts of detergent for this type of item Check the supply power Product Fiche BUILT-IN Installation Page 338 190 338 Use 35mm hinge cutting tool Page Page Page To increase height of product order optional part no Page Page Page Page UK Mainland & Northern Ireland Service once the manufacturers guarantee has expiredRepublic of Ireland What is not covered? What is covered?Important notes