Beko WI 1382 Installation, Appropriate installation location, Removing packaging reinforcement

Page 8

3Installation

Refer to the nearest Authorised Service Agent for installation of the product. To make the product ready for use, review the information in the user manual and make sure that the electricity, tap water supply and water drainage systems are appropriate before calling the Authorized Service Agent. If they are not, call a qualified technician and plumber to have any necessary arrangements carried out. C Preparation of the location and

electrical, tap water and waste water installations at the place of installation is under customer's responsibility.

BInstallation and electrical connections of the product must be carried out by the Authorized Service Agent. Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorized persons.

APrior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety.

C Make sure that the water inlet and discharge hoses as well as the power cable are not folded, pinched or crushed while pushing the product into its place after installation or cleaning procedures.

Appropriate installation location

•Place the machine on a rigid floor.

Do not place it on a long pile rug or similar surfaces.

•Total weight of the washing machine and the dryer -with full load- when they are placed on top of each other reaches to approx. 180 kilograms. Place the product on a solid and flat floor that has sufficient load carrying capacity!

•Do not place the product on the power cable.

•Do not install the product at places where temperature may fall below 0ºC.

•Place the product at least 1 cm away from the edges of other furniture.

Removing packaging reinforcement

Tilt the machine backwards to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon.

Removing the transportation locks

ADo not remove the transportation locks before taking out the packaging reinforcement.

ARemove the transportation safety bolts before operating the washing machine, otherwise, the product will be damaged.

1.Loosen all the bolts with a spanner until they rotate freely (C).

2.Remove transportation safety bolts by turning them gently.

8

EN

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Washing Machine Explanation of symbols Table of Contents Your washing machine OverviewTechnical specifications Intended use Important safety instructionsGeneral safety Childrens safety Installation Appropriate installation locationRemoving packaging reinforcement Removing the transportation locksConnecting water supply Connecting to the drainAdjusting the feet Raising the applianceFitting a different plug Electrical connectionElectrical requirements First use Disposing of packaging materialTransportation of the product Disposing of the old productPreparation Things to be done for energy savingSorting the laundry Preparing laundry for washingCorrect load capacity Loading the laundryDetergents and softeners Detergent DrawerDetergent drawer compartments are indicated below II Main Wash CompartmentPre-Wash Compartment StarchBleaches Eliminating lime formationTips for efficient washing Woolens/SilksSelecting a Program and Operating Your Machine Control panelDisplay symbols Turning the machine onProgram selection Main programsAdditional programs Spin Speed selection Temperature selectionSpecial programs Program and consumption table Page Auxiliary functions Time displayStarting the Program Progress of programChild-proof lock Switching the machine to standby modeChanging the selections after the program has started End of program Ending the program through cancellingProgram in rinse hold mode Maintenance and cleaning Detergent DrawerDraining any remaining water and cleaning the pump filter Into their positions and pushing the upper part of it Troubleshooting Tap is turned off. Open the inlet water taps fullyPage Select the proper temperature for the laundry to be washed Page Use smaller amounts of detergent for this type of item Check the supply power Product Fiche BUILT-IN Installation Page 338 190 338 Use 35mm hinge cutting tool Page Page Page To increase height of product order optional part no Page Page Page Page Republic of Ireland Service once the manufacturers guarantee has expiredUK Mainland & Northern Ireland Important notes What is covered?What is not covered?
Top Page Image Contents