Beko WI 1382 user manual Into their positions and pushing the upper part of it

Page 30

Place a large container at the end of the hose. Drain the water off into the container by pulling out the plug at the end of the hose. If the amount of water to be drained off is greater than the volume of the container, replace the plug, pour the water out and then resume the draining process.

After draining process is completed, replace the plug into the end of the hose and fit the hose back into its place.

If your product is not supplied with an emergency drain hose, do the following as shown in the figure below:

Place a large container in front of the filter to receive water flowing from the filter.

Loosen pump filter (anticlockwise) until water starts to flow out of it. Direct the flowing water into the container you have placed in front of the filter. You can use a piece of cloth to absorb any spilled water.

When there is no water left, turn the pump filter until it is completely loose and remove it.

Clean any residues inside the filter as well as fibers, if any, around the propeller region.

If your product has a water jet feature, be sure to fit the filter into its housing in the pump. Never force the filter while replacing it into its housing. Fit the filter fully into its housing; otherwise, water may leak from the filter cap.

4- Close the filter cap.

Close the two-piece filter cap of your product by pushing the tab on it.

Close the one-piece filter cap of your product by fitting the tabs on the bottom

into their positions and pushing the upper part of it.

30

EN

Image 30
Contents Washing Machine Explanation of symbols Table of Contents Your washing machine OverviewTechnical specifications Important safety instructions General safetyIntended use Childrens safety Removing packaging reinforcement InstallationAppropriate installation location Removing the transportation locksConnecting water supply Connecting to the drainAdjusting the feet Raising the applianceElectrical connection Electrical requirementsFitting a different plug Transportation of the product First useDisposing of packaging material Disposing of the old productSorting the laundry PreparationThings to be done for energy saving Preparing laundry for washingCorrect load capacity Loading the laundryDetergent drawer compartments are indicated below Detergents and softenersDetergent Drawer II Main Wash CompartmentBleaches Pre-Wash CompartmentStarch Eliminating lime formationTips for efficient washing Woolens/SilksSelecting a Program and Operating Your Machine Control panelProgram selection Display symbolsTurning the machine on Main programsAdditional programs Temperature selection Special programsSpin Speed selection Program and consumption table Page Auxiliary functions Time displayStarting the Program Progress of programSwitching the machine to standby mode Changing the selections after the program has startedChild-proof lock Ending the program through cancelling Program in rinse hold modeEnd of program Maintenance and cleaning Detergent DrawerDraining any remaining water and cleaning the pump filter Into their positions and pushing the upper part of it Troubleshooting Tap is turned off. Open the inlet water taps fullyPage Select the proper temperature for the laundry to be washed Page Use smaller amounts of detergent for this type of item Check the supply power Product Fiche BUILT-IN Installation Page 338 190 338 Use 35mm hinge cutting tool Page Page Page To increase height of product order optional part no Page Page Page Page Service once the manufacturers guarantee has expired UK Mainland & Northern IrelandRepublic of Ireland What is covered? What is not covered?Important notes