How to Install the One Touch Joint
便捷連接器的安裝
1 Confirm the diameter of the water tap. 確認水龍頭直徑。
If the diameter exceeds 2cm, remove the joint ring.
若水龍頭的外徑超過 2cm ，可將連接環 取出。
Screw 
螺釘
Joint ring
連接環
Label
One touch joint 標貼 便捷連接器
2 Check the distance between joints A and B.
確認接頭 A 、 B 之間的間隙。
Screw joint B in the arrow direction to adjust the gap.
沿箭咀方向旋轉接頭 B 調整間隙。
Joint
接頭
Approximately 6 |
約6 |
Joint
接頭
3 Press the sealed pad evenly against the tap and tighten the four screws in a uniform fashion.
將密封墊均勻地壓在水龍頭上，再將4個螺釘 均等地擰緊。
4 Tighten joint B in the arrow direction to reduce the gap between joint A and B to 4mm or less.
沿箭咀方向擰緊接頭B，使接頭A、B 之間的間隙在 4mm 以內。
Water tap
水龍頭
Sealed pad
密封墊
Joint 
接頭 
Tighten screw in advance if it is located close to the wall.
靠近牆壁的螺釘，可預先用手擰 進一些。
Joint 
接頭 |
Joint
接頭
(After tighten)
(擰緊後)
Less than4
約4 
以下
For water supply hose installation, please refer to "How to install water supply hose" in the user manual.
供水管的安裝參閱使用說明書中『供水管的安裝』一章。
Loosening may occur with extended use. In such case, reinstall the joint following steps 2 to 4.
長時間使用後，可能會因鬆脫而引起漏水，此時請按 2 ~ 4 的步驟重新安裝。
(Carry out the same steps when reinstalling the one touch joint at a change of residence, etc.) (搬家等需重新安裝便捷連接器時，請按照相同的步驟進行。)
Appropriate water tap Horizontal taps A and B as shown below.
適用的水龍頭橫式 A 、 B 型水龍頭最為適宜。
Horizontal tap A | Horizontal tap B | Square mouth tap | Universal household tap | Swivel tap |
橫式 A 型水龍頭 | 橫式 B 型水龍頭 | 方口水龍頭 | 萬能水龍頭 | 萬向水龍頭 |
Distance must be over 1.6cm in order to install correctly. 若無1.6cm以上的距離將無法 安裝。
May break off after install the one touch joint.
便捷連接器安裝後，可能 會脫落。
Water leakage may occur.
有可能會漏水。
11