John Lewis JLWM 1604 Start the programme, How to change an option or a programme during its cycle

Page 15

•Press 9 button again.

Cancelling the delayed start

•Press button 9.

•Press «Delay start» button once until the symbol «0’» is displayed.

•Press button 9 again.

The Delay Start cannot be selected with the draining programme.

Start the programme

To start the selected programme, press the button 9 ; the green pilot light stops flashing. If you have selected a delay time, the countdown will begin and will be shown on the display.

To interrupt a programme which is running, press button 9: the green pilot light starts to flash. To restart the programme from the point at which it was interrupted, press the button 9 again. If an incorrect option is selected, the red pilot light of button 9 flashes 3 times and the message Err is displayed for a few seconds.

Important!

You must set the washing machine to Pause before you make any change in the programme in progress.

How to change an option or a programme during its cycle

It is possible to change some options before the programme carries them out. Before you make any change, you must pause the washing machine by pressing the button 9. Changing a running programme is possible only by resetting it.

Turn the programme selector dial to «Off» and then to the new programme position. Start the new programme by pressing the

button 9. The washing water in the tub will not empty out

How to interrupt a programme

Press the button 9 to interrupt a programme which is running, the corresponding green pilot light starts blinking.

Press the same button again to restart the programme.

How to open the door during the cycle of a programme

You can open the door, after having set the washing machine to Pause, provided the following conditions exist:

•The washing machine is not in the heating phase

•The level of the water is not high;

If these requirements are met, when you pause the washing machine, the «Door lock» light goes off and the door can be opened.

Should it not be possible to open the door, and should it be absolutely necessary to do so, switch the machine off by turning the selector dial to Off. After a few minutes, you can open the door.

Pay attention to the level and temperature of the water in the washing machine! When you close the door to restart the programme turn the dial to the previous programme and repeat the options previously selected and press button 9.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Jlwm Spin washing machine General safety Safety informationUse InstallationKeep all detergents in a safe place out of children’s reach Child safetyContents Page Product description Detergent dispenser drawer Control panelExtra Rinse Programme DialSpin Easy IronStart Pause Delay StartDisplay QuickChild lock symbol Child lock Acoustic signals First use PersonalisationSelect the required programme Daily useLoad the laundry Measure out the detergentSelect the desired options Select the delay startSelecting the delayed start Opening the door throughout the delay timeCancelling the delayed start How to change an option or a programme during its cycleHow to interrupt a programme How to open the door during the cycle of a programmeBefore loading the laundry Helpful hints and tipsEnd of programme Sorting out the laundryBall point pen and glue moisten with Removing stainsDetergents and additives Quantity of detergent to be usedDegrees of water hardness Washing programmesWhite or fast colour cotton normally or slightly White or non fast colour cotton slightly soiledWhite and colour cotton normally soiled items Silk AutomaticColour cotton and synthetic items can be DelicatesMax. load 2 kg Spin phase, add more items, redistribute the loadMain wash Rinses Maximum spin speed atOff DrainSpin Minute washTechnical data Consumption valuesProgramme1 Energy consumption Water consumption KWh2 Litre2 Care and cleaning Door seal Cleaning the drawer recessCleaning the pump Washing drumPage Cleaning the water inlet filters Emergency emptying out Frost precautionUnpacking InstallationPlumbing Positioning and levellingWater-stop device Water inletWater drainage Into a drainage standpipeOnto a sink outlet spigot Interest of the environment Special conditionsElectrical connection Permanent connection Appliance is supplied with a 13 amp plug fittedDoes not start Problem Possible cause/SolutionWhat to do if… Washing machineMachine fills than Machine does not fillMachine does not Empty and/or does notMachine vibrates Unsatisfactory washingResults Door will not open0844 871 Repairs After Sales ServiceRepairs After Sales Service Spare partsEnvironment concerns Packaging materialsEcological hints Page Page Page 132944071-A-102011
Top Page Image Contents