JVC UX-H30 manual Connecting Speakers, Turn the AM loop antenna until you have the best reception

Page 10

AM (MW) antenna

1

Vinyl-covered wire

(not supplied)

2

AM loop antenna

(supplied)

1Connect the AM loop antenna to the AM LOOP terminals as illustrated.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM (MW) antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM (MW)

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the power cord.

Connecting Speakers

1	2
Speaker cord
	Speaker cord
Right speaker	Left speaker

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into

the terminal.

Match the polarity between the unit and the speaker terminals: ª to ª and · to ·.

3Release your finger from the clamp.

•DO NOT connect speakers while the power is on.

•DO NOT connect more than one speaker to each speaker teminal.

IMPORTANT: Use only speakers with the same speaker impedance as shown on the speaker terminals on the rear of the unit.

7

Image 10

Contents Micro Component System Important for Laser Products UX-H35/UX-H33/UX-H30 Introduction PrecautionsAbout This Manual Contents Top view Location of the ButtonsMain Unit Front viewDisplay window Main unit Display windowRemote Control Tape Tuner AUXGetting Started Supplied AccessoriesConnecting Antennas FM antennaRelease your finger from the clamp Connecting SpeakersTurn the AM loop antenna until you have the best reception To connect an outdoor AM MW antennaTo remove the speaker grilles Connecting Other EquipmentTo connect the AC power cord To connect an audio equipmentPutting the Batteries into the Remote Control When using the unit in your carSetting the Clock Common OperationsAdjusting the Tone Bass/Treble Turning On the PowerAdjusting the Volume Reinforcing the Bass SoundTuning in to a Station Presetting StationsTuning in to a Preset Station Receiving FM Stations with RDSPress Display orange-colored. Display Changing the RDS InformationSearching for Programs by PTY Codes PTY Search Press PTY SearchData type you want Appears on the display Switching Temporarily to a Program Type of Your ChoicePress TA/NEWS/INFO until Wait for about 3 seconds after Specifying the data typePress 0 Open on the unit When playing a CD-R or CD-RWPlaying Back Discs General notesBasic Disc Operations Programming the Playing Order of the Tracks-Program PlayRepeating Tracks-Repeat Play To check the program contentsPlaying at Random-Random Play Press RandomPress for cassette deck on the unit Playing Back TapesPlaying Back a Tape Put a cassette in with the exposed part of the tape downRecording on a Tape To record on both sides-Reverse ModeRecording To protect your recordingPress ONE Touch Disc Direct RecordingOne Track Recording Repeat steps 2 and 3 to record other tracks you wantSet the on-time when you want the unit To turn on Using the TimersUsing Daily Timer and Recording Timer Set the off-time when you want the unit To turn off standbyTo deactivate the timer temporarily Adjust the clock if you needSelect the volume level With the source to playHow the Sleep Timer actually works Using Snooze TimerUsing Sleep Timer Press SleepHandling cassette tapes MaintenanceCleaning the unit Handling discsCause TroubleshootingSymptom ActionDescription of the PTY codes Alarm functionAdditional Information Test functionSpecifications 0103MWMMDWJEM