JVC UX-H30, CA-UXH33, SP-UXH33 manual Using the Timers, Using Daily Timer and Recording Timer

Page 25

Using the Timers

Continued

There are four timers available—Daily Timer, Recording Timer, Snooze Timer, and Sleep Timer. Before using the timers, you need to set the unit’s

2Set the on-time when you want the unit

to turn on.

UP

clock (see page 10).

Using Daily Timer and Recording Timer

You can set the timer whether the unit is on or off.

How the timer actually works

When the on-time comes, the unit automatically turns on (the [timer] indicator flashes just before the on- time and continues flashing while the timer is operating). Then, when the off-time comes, the unit automatically turns off (standby).

The timer setting remains in memory until you change

On the remote control:

1)Press UP or DOWN to set the hour, then press

CLOCK/TIMER.

2)Press UP or DOWN to set the minute, then press

CLOCK/TIMER.

On the unit:

1)Press ¢ or 4 to set the hour, then press TIMER/ SNOOZE.

2)Press ¢ or 4 to set the minute, then press

TIMER/SNOOZE.

DOWN

CLOCK / TIMER

TIMER/SNOOZE

it.

When the (timer) indicator is lit on the display, the timer acts as the Daily Timer. Once the timer has been set, it will be activated at the same time everyday until the timer is turned off.

When the (timer) and the REC indicators are lit on the display, the timer acts as the Recording Timer. After the timer-recording finishes, the details of the setting remain stored but the timer is turned off.

Before you start...

When using “ TUNER” as the source to play, make sure to select the desired station before turning off the power.

There is a time limit in doing the following steps. If the setting is canceled before you finish, start over from step 1.

The OFF indicator lights up and the unit enters off-time setting mode.

OFF

3Set the off-time when you want the unit

to turn off (standby).

On the remote control:

1)Press UP or DOWN to set the hour, then press CLOCK/TIMER.

2)Press UP or DOWN to set the minute, then press CLOCK/TIMER.

On the unit:

1) Press ¢ or 4 to set the hour, then press

1Press CLOCK/TIMER (or TIMER/SNOOZE on the unit).

The (timer) and the ON indicators light up and the current on-time flashes on the display.

The unit enters on-time setting mode.

CLOCK / TIMER

TIMER/SNOOZE

TIMER/SNOOZE.

2) Press ¢ or 4 to set the minute, then press

TIMER/SNOOZE.

The unit enters the timer selecting mode.

ON

22

Image 25
Contents Micro Component System Important for Laser Products UX-H35/UX-H33/UX-H30 Introduction PrecautionsAbout This Manual Contents Main Unit Location of the ButtonsTop view Front viewMain unit Display window Display windowTape Tuner AUX Remote ControlConnecting Antennas Supplied AccessoriesGetting Started FM antennaTurn the AM loop antenna until you have the best reception Connecting SpeakersRelease your finger from the clamp To connect an outdoor AM MW antennaTo connect the AC power cord Connecting Other EquipmentTo remove the speaker grilles To connect an audio equipmentWhen using the unit in your car Putting the Batteries into the Remote ControlCommon Operations Setting the ClockAdjusting the Volume Turning On the PowerAdjusting the Tone Bass/Treble Reinforcing the Bass SoundPresetting Stations Tuning in to a StationReceiving FM Stations with RDS Tuning in to a Preset StationSearching for Programs by PTY Codes PTY Search Changing the RDS InformationPress Display orange-colored. Display Press PTY SearchPress TA/NEWS/INFO until Switching Temporarily to a Program Type of Your ChoiceData type you want Appears on the display Wait for about 3 seconds after Specifying the data typePlaying Back Discs When playing a CD-R or CD-RWPress 0 Open on the unit General notesProgramming the Playing Order of the Tracks-Program Play Basic Disc OperationsPlaying at Random-Random Play To check the program contentsRepeating Tracks-Repeat Play Press RandomPlaying Back a Tape Playing Back TapesPress for cassette deck on the unit Put a cassette in with the exposed part of the tape downRecording To record on both sides-Reverse ModeRecording on a Tape To protect your recordingOne Track Recording Disc Direct RecordingPress ONE Touch Repeat steps 2 and 3 to record other tracks you wantUsing Daily Timer and Recording Timer Using the TimersSet the on-time when you want the unit To turn on Set the off-time when you want the unit To turn off standbySelect the volume level Adjust the clock if you needTo deactivate the timer temporarily With the source to playUsing Sleep Timer Using Snooze TimerHow the Sleep Timer actually works Press SleepCleaning the unit MaintenanceHandling cassette tapes Handling discsSymptom TroubleshootingCause ActionAdditional Information Alarm functionDescription of the PTY codes Test functionSpecifications 0103MWMMDWJEM