Troubleshooting
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.
Symptom
No sound is heard.
Hard to listen to broadcasts because of noise.
The disc does not play.
The disc sound is discontinuous.
The cassette holder cannot be opened.
Impossible to record.
Operations are disabled.
Unable to operate the unit from the remote control.
Cause
•Connections are incorrect or loose.
•Headphones are connected.
•Antennas are disconnected.
•The AM loop antenna is too close to the unit.
•The FM antenna is not properly extended and positioned.
The disc is placed upside down.
The disc is scratched or dirty.
Power from the power cord has been cut off while the tape was running.
Small tabs on the back of the cassette are removed.
The
•The path between the remote control and the remote sensor on the unit is blocked.
•The batteries are exhausted.
Action
•Check all connections and make corrections. (See pages 6 – 9.)
•Disconnect the headphones.
•Reconnect the antennas correctly and securely.
•Change the position and direction of the AM loop antenna.
•Extend the FM antenna to the best position.
Place the disc with the label side up.
Clean or replace the disc. (See page 25.)
Plug in the power cord, then turn on the unit.
Cover the holes with adhesive tape.
Unplug the power cord and then plug it back in.
•Remove the obstruction.
•Replace the batteries.
26