JVC UX-H30, CA-UXH33 Playing Back Tapes, Playing Back a Tape, Press for cassette deck on the unit

Playing Back Tapes

You can play back type I tapes.

Playing Back a Tape

1Press ) for cassette deck on the unit.

The cassette holder opens.

2Put a cassette in with the exposed part of the tape down.

If no cassette is inserted when you press 2 3 TAPE

“NO TAPE” appears on the display.

To stop playing, press 7.

To fast-wind to the left or to the right, press ¢ or 4 while the tape is not running.

The tape direction indicator (3 or 2) starts flashing rapidly on the display.

To remove the cassette, press ) on

the unit.

To play both sides—Reverse Mode

You can set the deck to play just one side of a tape, both sides once, or both sides continuously.

On the remote control ONLY:

Press REV.MODE (reverse mode). REV.MODE

•Each time you press the button, the Reverse Mode changes as follows:

3

4

Close the cassette holder cover gently.

Press 2 3 TAPE. TAPE

The unit automatically turns on and the tape starts playing. The tape direction indicator (3 or 2) flashes slowly on the display.

•Each time you press the button, the tape direction changes:

3 : plays the front side.

2 : plays the reverse side.

When the tape plays to the end, the deck automatically stops if the Reverse Mode is set to or . (See “To play both sides—Reverse Mode.”)

: The deck automatically stops after playing both sides of the tape. Stops when playback in the 2 direction is finished.

: The deck continues to play both sides of the tape until 7 is pressed.

: The deck automatically stops after playing one side of the tape.

The use of C-120 or thinner tape is not recommended, since characteristic deterioration may occur and this tape easily jams in the pinch-rollers and the capstans.

19