Whirlpool W10063560 manual PausingorRestarting, ChangingCycles andOptions, StatusLights

PausingorRestarting

1.To pause the washer at any time, select PAUSE/CANCEL.

2.To continue the cycle, select and hold START (for approximately 1 second).

ChangingCycles andOptions

Not all Options are available with all Cycles.

Cycles and Options can be changed anytime before START is selected.

To stop a cycle and select a new cycle

1.Select PAUSE/CANCEL once.

2.Select desired cycle.

3.Select the desired OPTIONS.

4.Select and hold START (for approximately 1 second) to restart the washer at the beginning of the new cycle.

To cancel a cycle

1.Select PAUSE/CANCEL twice.

2.The washer powers down, the door unlocks, and clothes can be removed.

NOTE: If the water level or the temperature is too high, the washer will drain automatically before the door unlocks.

To change Options after the cycle has started

1.Select PAUSE/CANCEL once.

2.Select the desired OPTIONS. If the option is not available, the machine will beep.

3.Select and hold START (for approximately 1 second) to continue the cycle.

To drain the washer manually

1.Select PAUSE/CANCEL.

2.Select DRAIN/SPIN.

3.Select and hold START (for approximately 1 second) to begin the drain.

4.When the spin is complete, the door unlocks. Items can be removed from the washer.

StatusLights

These lights show which portion of the cycle the washer is operating. They also indicate when you can add an additional item to the wash cycle and when the controls are locked.

Adding items

You can add items to the washer after the wash cycle has started, if the ADD A GARMENT status light is illuminated. All cycles have this feature except Rinse/Spin, Drain/Spin, and Clean Washer.

To add items

1.Select PAUSE/CANCEL. The washer door unlocks, and items can be added.

2.To continue the cycle, close the door and select and hold START (for approximately 1 second).

3.To unlock the door after the Add a Garment period, press PAUSE/CANCEL twice. This will cancel the Wash Cycle.

Cycle Complete

The Cycle Complete light stays on for 5 minutes after the cycle is complete. The washer will then power down.

Locking controls

The Control Lock avoids unintended use of the washer. You can also use the control lock feature to avoid unintended cycle or option changes during a cycle. When CONTROL LOCKED is lit, all buttons are disabled except for PAUSE/CANCEL and START. You can lock the controls while the washer is operating.

To lock the controls

Select and hold END OF CYCLE SIGNAL for 3 seconds.

The CONTROL LOCKED status light illuminates.

To unlock the controls

Select and hold END OF CYCLE SIGNAL for 3 seconds until the CONTROL LOCKED Status light turns off.

Estimated Time Remaining

The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load. The cycle time will be extended if oversudsing occurs or the load is unbalanced. The SUDs routine removes extra suds and assures proper rinsing of your garments. The options you select will also affect the cycle times that are shown in the Preset Cycle Settings table. The Estimated Time Remaining can change up to 30 minutes under extreme conditions.

Door Locked

When the status light illuminates, the door is locked. The door is locked and unlocked automatically, depending on the stage of the wash cycle.

14