14Daily use
•Press button 7 : the appliance starts its hourly countdown. The programme will start
after the selected delay has expired. Cancelling the delayed start
•Set the washing machine to PAUSE by pressing the button 7 ;
•Press button 8 until the symbol 
’ is displayed;
•Press the button 7 again to start the programme.
The selected delay can be changed only after selecting the washing programme again.
The Delay Start can not be selected with the draining programme.
Altering an option or a running programme
It is possible to change some options before the programme carries it out. Before you make any change, you must pause the washing machine by pressing the button 7 . Changing a running programme is possible only by resetting it . Turn the programme
selector dial to 
and then to the new programme position. Start the new programme by pressing the 7 button again. The washing water in the tub will not emptied out.
Interrupting a programme
Press the button 7 to interrupt a programme which is running, the corresponding light starts blinking. Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to 
to cancel a programme which is running. Now you can select a new programme.
Opening the door after the programme has started
When the machine is working and through the delay time, the door is locked. If, for any reason, it is necessary to open it, set firstly the machine to pause by pressing the button
7.
•If the DOOR symbol disappears from the display, the door can be opened.
•If the DOOR symbol stays on, and the door remains locked, this means that the ma- chine is already heating or that the water level is too high. In this case the door can
not be opened.
If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to 
. After a few minutes the door can be opened (pay attention to the water level and temperature !) .
After closing the door, it is necessary to select the programme and options again and to press button 7 .
At the end of the programme
The machine stops automatically. The pilot light of button 7 goes off and a blinking 
appears on the display. The acoustic signal sounds for a few minutes.
If you have chosen a programme or an option that ends with water left in the tub, fol- low the below instruction to empty the water out:
•turn the programme selector dial to 
•select the draining or spinning programme