Electrolux 16850A Drain hose is squashed or kinked, Check the drain hose connection, Gramme, Drum

	What to do if…
30
	Problem		Possible cause/Solution
		The drain hose is squashed or kinked.
		•	Check the drain hose connection.
		The drain filter is clogged.
		•	Clean the drain filter.
	The machine does not empty and/or does	An option or a programme that ends with the
		water still in the tub or a that eliminates all
	not spin:	the spinning phases has been selected.
		•	Select the draining or the spinning pro-
			gramme.
		The laundry is not evenly distributed in the
		drum.
		•	Redistribute the laundry.
		Too much detergent or unsuitable detergent
		(creates too much foam) has been used.
		•	Reduce the detergent quantity or use an-
			other one.
		Check whether there are any leaks from one
		of the inlet hose fittings. It is not always easy
		to see this as the water runs down the hose;
	There is water on the floor:	check to see if it is damp.
		•	Check the water inlet hose connection.
		The drain or the inlet hose is damaged.
		•	Replace it with a new one.
		The cap on the filter has not been replaced or
		the filter has not been properly screwed in af-
		ter cleaning action.
		•	Refit the cap on the filter or screw the filter
			fully in.
		Too little detergent or unsuitable detergent
		has been used.
		•	Increase the detergent quantity or use an-
			other one.
		Stubborn stains have not been treated prior to
	Unsatisfactory washing results:	washing.
		•	Use commercial products to treat the stub-
			born stains.
		The correct temperature was not selected.
		•	Check if you have selected the correct tem-
			perature.
		Excessive laundry load.
		•	Reduce the laundry load.
		The programme is still running.
		•	Wait the end of washing cycle.
	The door will not open:	The door lock has not been released.
		•	Wait until the symbol 9.4 has gone off.
		There is water in the drum.
		•	Select drain or spin programme to empty
			out the water.