Pitney Bowes W863, W983 manual Adjust Media Stop

W983 Stacker/W863 Dryer Operating Guide

To adjust the distance:

1Unlock wheels if they are locked.

2Move the Stacker to the recommended distance from the printer output roller and lock the wheels. Refer to tables and graphs on pages 15-19 to determine the value.

Adjust Media Stop

The media stop is adjusted so that mailpieces from the printer hit the stop and drop flat onto the conveyor belt. There are two adjustments on the media stop: height and depth.

Depth

Knobs

Depth

Scales

Height Adjustment Knob

To adjust the height:

•Loosen the knob on the side of the media stop and slide the plate up or down. For 1/16” thickness, slide a sample mailpiece under the balls and lower the media stop to the point of contact and then lock. For over 1/16” thickness, set the media stop low enough so that mailpiece cannot get below the edge of the media stop and then lock.

To adjust the depth:

•There is a scale on the media stop that is used to set up for different size mailpieces. Loosen the two knobs and set the knobs to the desired value on the scale. Refer to tables and graphs on pages 15-19 to determine the value. Tighten the knobs when you are finished.

12 SV61228 Rev. A