Pitney Bowes W983, W863 manual Adjust Stacker Full Arm

W983 Stacker/W863 Dryer Operating Guide

Adjust Stacker Full Arm

This consists of making two adjustments: locating the full arm fixture on the ramp and locating a metal tip on the full arm. There is a scale on the ramp and one on the arm that are used to set up for different size material. Refer to the table on page 15 to determine the recommended values.

Knob

Arm Fixture (knob under

ramp)

Arm

Scales

To adjust the full arm fixture on the ramp:

•Loosen the knob on the bottom of the ramp holding the fixture. Move the fixture so that the lower end of the box aligns with the desired value on the scale. Refer to tables and graphs on pages 15-19 to determine the value. Tighten the knob when you are finished.

To adjust the full arm metal tip:

•Loosen the knob holding the metal tip to the arm. Slide the knob to the desired value on the scale. Refer to the table on page 15 to determine the value. Tighten the knob when you are finished.

SV61228 Rev. A 13