Pitney Bowes W863, W983 manual FCC Compliance

Page 3

FCC Compliance

This equipment had been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against interference when the equipment is operated in a commercial en- vironment. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the users manuals, may cause harmful interference to radio commu- nications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

CAUTION: Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Shielded cables must be used with this unit to insure compliance with Class A limits.

Canadian DOC Compliance

This digital apparatus does not exceed in the Class A limits for radio noise emissions from digital apparatus set out in the Interference- causing Equipment Regulations (Standard ICES-003) of the Cana- dian Department of Communications.

Le present appareil numerique n’emet pas de bruits radioelectriques depassant les limites applicables aux appareils numeriques de la class A prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des Communications du Canada.

NOTE: This equipment has been tested and found to comply with the U.S. Standard for Safety UL1950, Third Edition, Safety of Information Technology Equipment including Electrical Business Equipment and Canadian Standards C22.2 No 950-95, Third Edition, Safety of Infor- mation Technology Equipment including Electrical Business Equipment.

First Edition, March 2004

© 2004 Pitney Bowes Inc.

All rights reserved. This book may not be reproduced in whole or in part in any fashion or stored in a retrieval system of any type or transmitted by any means, electronically or mechanically, without the express written permission of Pitney Bowes Inc.

We have made every reasonable effort to assure the accuracy and usefulness of this manual, however, we cannot assume responsibility for errors or omissions or liability for the misuse or misapplication of our products. AddressRight® is registered trademark of Pitney Bowes.

Image 3
Contents Page W983 Power Stacker W863 Ink Dryer FCC Compliance Table of Contents Table of Contents Safety Summary W983 Stacker/W863 Dryer Operating Guide Operator Panel W983 Power Stacker Controls and IndicatorsConveyor Deck Connector and Side Panels Optional Stand for Power Stacker Stacker Materials Specifications Stacker Technical SpecificationsFull Arm Fixture and Full Arm Tip Stacker Setup GuidelinesHold Down Assembly Media Stop, Stacker Height and DistanceStacker Job Setup Adjust Stacker Height and DistanceSpeed Control Adjust Media Stop Adjust Stacker Full Arm Full Light Red LED Adjust Hold DownsAuto/Manual Switch Power SwitchW983 Stacker Setup Table Media Stop Setting Full Arm Fixture Setting Stacker Height and Distance Super Draft & Draft Mode Stacker Height and Distance Letter Mode Stacker Height and Distance Executive Mode Smudged Addresses Stacker Tips and TroubleshootingCleaning Fuse ReplacementDryer Technical Specifications Controls and IndicatorsOptional W863 Ink Dryer Dryer Operation Adjust Dryer Height Dryer Job SetupDryer Tips and Troubleshooting W983 Stacker/W863 Dryer Operating Guide Symptom Possible Cause Remedy Dryer Troubleshooting Table