Pitney Bowes W983, W863 manual Stacker Height and Distance Executive Mode

W983 Stacker/W863 Dryer Operating Guide

STACKER HEIGHT AND DISTANCE - EXECUTIVE MODE

Vertical Distance (in inches) -	Conveyor Deck to DA Printer Output Roller
	W983
inches) -	Output Roller
Horizontal Distance (in	W983 Stacker to DA Printer

5.5
	Max.	thickness=3/8	”
5.0
4.5
4.0
3.5
3.0
2.5
2.0
	Min.	thickness=0	”
1.5
1.0
0.5
0

5.0	5.5	6.0	6.5	7.0	7.5	8.0	8.5	9.0	9.5	10.0	10.5	11.0		11.5		12.0	12.5		13.0
					Material Length (in inches)
5.5
5.0
4.5
4.0
3.5
3.0
2.5
													Max.		thickness=3/8			”
2.0
1.5
1.0
													Min.		thickness=0			”
0.5
0
5.0	5.5	6.0	6.5	7.0	7.5	8.0	8.5	9.0	9.5	10.0	10.5	11.0		11.5		12.0	12.5		13.0

Material Length (in inches)

The top chart is used to determine the distance to set between the Stacker deck and the DA Printer output roller. This is done by adjusting the height of the stand.

The bottom chart is used to determine the distance from the Stacker to the output roller. This is done by moving the Stacker closer or farther from the DA Printer output roller.

In order to use the charts:

1Measure the length and thickness of your material in inches.

2Go to the length at the bottom of the chart and then up that line to the thickness (the thickness must be approximated in the gray area which represents 3/8” between the Min. thickness and Max. thickness).

3Follow a straight line to the left side of the chart. That is the distance in inches for that setting.

For example: if the material is 11 inches long and 1/8 inch thick, the reading on the top chart would be approximately 4 inches and on the bottom chart approxi- mately 1.25 inches.

SV61228 Rev. A 19