Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band
1 Select the band (in this example, FM1).
Tuning in to a preset station
You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 10 and 11.
1 Select the band.
ATT | 1 Press SOURCE ATT to |
ENGLISH
ATT
SOURCE
BAND
MODE
M
1Press SOURCE ATT to select FM as the source.
2Press and hold BAND MODE (M) repeatedly to select the FM1 band.
SOURCE | select FM or AM as the |
| |
| source. |
BAND | 2 If necessary, press and |
MODE |
|
Mhold BAND MODE (M) to
select the FM band number (FM1, FM2 or FM3).
2 Tune in to a station (in this example, of 88.3 MHz).
Press 
¢ to tune in to stations of higher frequencies.
Press 4 
to tune in to stations of lower frequencies.
DIRECTORY
FILEDISC
TRACK
CEQ | ST RPT | RND | TP PTY |
3 Press and hold the number button (in this example, 1) for more than 2 seconds.
EQ
17
DIRECTORY
FILEDISC
TRACK
CEQ | ST RPT | RND | TP PTY |
“PI” flashes for a few seconds.
4 Repeat the above procedure to store other stations into other preset numbers.
Notes:
•A previously preset station is erased when a new station is stored in the same preset number.
•Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.
Each time you press and hold the button, the FM band changes as follows:
FM1 
FM2 
FM3
2 Select the number (1 – 6) for the preset station you want.
EQ | MONO |
| INT | RPT | RND |
1 7 | 2 8 | 3 9 | 10 | 5 11 | 612 |
If the sound quality decreases and the stereo effect is lost while listening to an FM station
In some areas, adjacent stations may interfere with each other. If this interference occurs, this unit can automatically reduce this interference noise (the initial setting when shipped from the factory). However, in this case, the sound quality will be degraded and the stereo effect will be also lost.
If you do not want to degrade the sound quality and to lose the stereo effect, rather than to eliminate the interference noise, see “To change the FM tuner selectivity — IF FILTER” on page 28.
11