IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basic precautions, including the following:
■Read all instructions before using the washer.
■Do not wash articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline,
■Do not add gasoline,
■Under certain conditions, hydrogen gas may be produced in a hot water system that has not been used for 2 weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot water system has not been used for such a period, before using the washing machine, turn on all hot water faucets and let the water flow from each for several minutes. This will release any accumulated hydrogen gas. As the gas is flammable, do not smoke or use an open flame during this time.
■Do not allow children to play on or in the washer. Close supervision of children is necessary when the washer is used near children.
■Before the washer is removed from service or discarded,
remove the door or lid.
■Do not reach into the washer if the drum, tub or agitator is moving.
■Do not install or store the washer where it will be exposed to the weather.
■Do not tamper with controls.
■Do not repair or replace any part of the washer or attempt any servicing unless specifically recommended in this manual or in published
■See “Electrical Requirements” for grounding instructions.
Tools and Parts
Gather the required tools and parts before starting installation.
Tools needed
■Level
■Utility knife
■Scissors
■8" or 10" adjustable wrench
■
■Pliers
■Bucket
Parts supplied
Remove parts bag from washer. Check that all parts were included.
■1 hose clamp
■2 inlet hoses
■4 flat water hose washers
■2
■1 drain hose
You will need:
■A water heater set to deliver 120°F (49°C) water to the washer.
■A grounded electrical outlet located within 4 ft (1.2 m) of where the power cord is attached to the back of the washer.
See “Electrical Requirements.”
■Hot and cold water faucets located within 4 ft (1.2 m) of the back of the washer, and provide water pressure of
■A level floor with a maximum slope of 1" (2.5 cm) under entire washer.
■A sturdy floor to support the washer weight (washer, water and load) of 315 lbs (143 kgs).
■A 12" (30 cm) minimum riser to provide an air cushion and prevent noise and damage to valves for a single washer installation.
■A floor drain should be provided under the bulkhead. Prefabricated bulkheads with electrical outlets, water supply lines and drain facilities should be used only where local codes permit.
NOTE: Front access to the pump area is available by removing 2 No. T20 TORX® security screws and then removing the front panel.
Location Requirements
IMPORTANT : Do not install or store the washer where it will be exposed to the weather. Do not store or operate the washer in temperatures at or below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures.
Proper installation is your responsibility.
® Registered trademark of TEXTRON | 3 |