Complete Installation Checklist

qCheck that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

qCheck that you have all of your tools.

qDispose of/recycle all packaging materials. Keep the plastic foam for use if the washer/dryer should be transported.

qCheck the washer/dryer’s final location. Be sure the vent is not crushed or kinked.

qCheck that the washer/dryer is level and front leveling feet are tight. See “Level Washer/Dryer.”

qFor power supply cord installation, plug into a grounded outlet. For direct wire installation, turn on power.

qCheck that the water faucets are on.

qCheck for leaks around faucets and inlet hoses.

qRemove the blue protective film on the console and any tape remaining on the washer/dryer.

qRead the Washer/Dryer Use and Care Guide.

qWipe the dryer drum interior thoroughly with a damp cloth to remove any dust.

qTo test the washer, measure 1/2 the normal recommended amount of detergent and pour it into the washer. Close the lid. Select REGULAR and pull out the Cycle Control knob. Allow the washer to complete one whole cycle.

qTo test the dryer, set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer.

If the dryer will not start, check the following:

•Controls are set in a running or “On” position.

•START button has been firmly pushed.

•Washer/dryer is plugged into a grounded outlet.

•Electrical supply is connected.

•Household fuses are intact and tight, or circuit breakers have not tripped.

•Dryer door is closed.

qWhen the dryer has been running for 5 minutes, open the dryer door and feel for heat.

If you do not feel heat, turn off the dryer and check the following:

•There may be 2 household fuses or circuit breakers for the dryer. Check that both fuses are intact and tight, or that both circuit breakers have not tripped. If there is still no heat, contact a qualified technician.

NOTE: You may notice an odor when dryer is first heated. This odor is common when the heating element is first used. The odor will go away.