CONNECT INLET HOSES | CONNECT VENT |
6. Check for leaks | 1. Connect vent to exhaust outlet |
Turn on water faucets to check for leaks. A small amount of water may enter washer. It will drain later.
7. Secure drain hose
Using a 4" (102 mm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure vent is clean. Dryer vent must fit over dryer exhaust outlet and inside exhaust hood. Check that vent is secured to exhaust hood with a 4" (102 mm) clamp.
Laundry Tub | Standpipe | Wall | 2. Move washer/dryer to final location |
|
|
| |
1 | 4.15"/2" |
| 1 |
4.5" | (114 mm) |
| 4.5"2 |
4.45"/2" |
| / | |
(114 mm) |
|
| (1143 mm) |
(114 mm) |
|
|
|
Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with tie strap (included in parts package).
Move washer/dryer to final location, taking care not to crush or kink vent.
After washer/dryer is in place, remove corner posts and cardboard from under washer/dryer.
20